Bradford-White Corp MITW -10, MITW -12 / -15 manual Do not over tighten 2 screws attaching

TTW1 Universal Service

Replacement Blower

MITW -12 / -15 Series

Step 13. Locate new blower harness, P/N 239-47194-00, provided with the kit. Route loose wire ends (yellow, blue, white, and green) through knock-out opening from Step 12c.

Step 14. Fasten conduit connector to the junction box.

Route wires

through hole in

junction box.

Fasten connector

to junction box.

Step 15. Connect the wire terminals to their corresponding locations on the transformer:

a.) (2) Blue wires and wire terminal to the

120V-Hot post

b.) (2) White wires and wire terminal to the 120V-Common post

c.) (2) Yellow wires and wire terminal to

the 24V-Hot post

d.) (2) Green wires and wire terminal to the 24V-Common post

Connect wire terminals from

harness to proper posts.

Warning:	Do NOT over tighten (2) screws attaching
	the transformer and junction box to the
	water heater.
Step 16.	Place the transformer all the way back
	into the junction box and fasten both to
	the water heater using (2) screws, P/N
	239-44113-00, provided with the kit.
	Fasten transformer and
	junction box to jacket head
	(Second screw not shown).

Page 18