Bradford-White Corp MITW -12 / -15, MITW -10 manual M1TW60T*FCX

Page 21

TTW1 Universal Service

Replacement Blower

M1TW Series

Note: This set of instructions is for the following model numbers:

M1TW40S*BN, M1TW40S*CX, M1TW50S*BN,

M1TW50S*CX, M1TW40S*FBN, M1TW40S*FCX,

M1TW50S*FBN, M1TW50S*FCX, M1TW60T*FBN, and

M1TW60T*FCX.

Note: The following parts are required to convert the model numbers shown above: Screws, Universal Blower, Dilution Air Orifice, Pressure Switch (-0.70" wc, for high altitude only), and 2" Exhaust Adapter / Vent Terminal Kit. Please refer to the Kit Components page (Page 3) for a picture of each item.

Step 1. On the water heater’s gas control, turn the power switch to the “Off” position.

Turn switch on gas valve

to “Off” position.

Step 2. Unplug water heater from wall outlet.

Remove power cord from outlet.

Unplug blower harness cord sets from blower housing receptacles.

Step 3. Disconnect blower cord sets from receptacles located in the blower housing.

Page 21

Page 20 Page 22
Image 21
Page 20 Page 22
Contents Instructions for Model Numbers Reference Kit Components Tools Required Bradford White TTW1 Universal Service Replacement Blower Step Remove the screws, qty , that secure Inside the access compartment, follow Just below the crimp connector, cut Plug both the blower Check all safety devices to make sure they Unplug the water heater from wall outlet Mitw -12 / -15 Series Place template on top of water heater in correct orientation TTW1 Universal Service Replacement Blower Secure Cover Screws Blower screws TTW1 Universal Service Replacement Blower Do not over tighten 2 screws attaching Tighten 2 screws on junction Box to secure cover Operation could occur if these devices are not M1TW60T*FCX TTW1 Universal Service Replacement Blower TTW1 Universal Service Replacement Blower Secure Cover screws Boot back Place Secure 3 blower screws Step If the new adapter is used, remove the old
Top Page Image Contents