Bradford-White Corp MITW -12 / -15, MITW -10 manual Boot back Place Secure 3 blower screws

Page 25

TTW1 Universal Service

Replacement Blower

M1TW Series

Step 9.

c.) Replace the intake boot back onto the blower. If it is necessary, the cable, or zip, tie can be removed from the boot to allow for easier assembly.

Replace boot on

rear of blower.

Remove cable tie if boot will not go onto rear of blower easily.

Step 10. Now that the universal blower is properly modified for a M1TW series water heater, the blower can be properly positioned and secured on top of the water heater. To place the blower on the water heater, feed the blower from around the backside of the water connections. Secure the universal blower using (3) screws, P/N

239-44113-00, provided with the kit, into the pre-existing holes used to fasten the original blower. Tighten them using a ¼” nut driver.

Plug blower harness cord sets into blower housing receptacles.

Step 11. With the blower securely fastened to the water heater, the blower wire harness cord sets can now be re-connected to the blower housing.

Boot back

in place.

Secure (3) blower screws.

Page 25

Page 24 Page 26
Image 25
Page 24 Page 26
Contents Instructions for Model Numbers Reference Kit Components Tools Required Bradford White TTW1 Universal Service Replacement Blower Step Remove the screws, qty , that secure Inside the access compartment, follow Just below the crimp connector, cut Plug both the blower Check all safety devices to make sure they Unplug the water heater from wall outlet Mitw -12 / -15 Series Place template on top of water heater in correct orientation TTW1 Universal Service Replacement Blower Secure Cover Screws Blower screws TTW1 Universal Service Replacement Blower Do not over tighten 2 screws attaching Tighten 2 screws on junction Box to secure cover Operation could occur if these devices are not M1TW60T*FCX TTW1 Universal Service Replacement Blower TTW1 Universal Service Replacement Blower Secure Cover screws Boot back Place Secure 3 blower screws Step If the new adapter is used, remove the old
Top Page Image Contents