Bradford-White Corp MITW -10, MITW -12 / -15 manual Secure Cover screws

Page 24

TTW1 Universal Service

Replacement Blower

M1TW Series

Step 8.

b.) Place the access compartment cover back on the blower and secure it with its (3) screws from Step 7a. Start the lower screw first, and when doing so, make sure that the hole in the pressure switch’s bracket matches up to the hole in the blower housing.

Secure (3)

cover screws.

Step 9. a.) Remove the intake boot from the rear of the blower.

b.) Place dilution air orifice, P/N 239-47190-00, in the hole, located in the rear of the blower, being sure to adjust the slot in the orifice such that it is horizontal, as shown.

Insert dilution air orifice into area concealed by boot. Orient slot in orifice to horizontal position.

Remove air intake boot.

Page 24

Page 23 Page 25
Image 24
Page 23 Page 25
Contents Instructions for Model Numbers Reference Kit Components Tools Required Bradford White TTW1 Universal Service Replacement Blower Step Remove the screws, qty , that secure Inside the access compartment, follow Just below the crimp connector, cut Plug both the blower Check all safety devices to make sure they Unplug the water heater from wall outlet Mitw -12 / -15 Series Place template on top of water heater in correct orientation TTW1 Universal Service Replacement Blower Secure Cover Screws Blower screws TTW1 Universal Service Replacement Blower Do not over tighten 2 screws attaching Tighten 2 screws on junction Box to secure cover Operation could occur if these devices are not M1TW60T*FCX TTW1 Universal Service Replacement Blower TTW1 Universal Service Replacement Blower Secure Cover screws Boot back Place Secure 3 blower screws Step If the new adapter is used, remove the old
Top Page Image Contents