Bradford-White Corp MITW -10, MITW -12 / -15 manual Operation could occur if these devices are not

Page 20

TTW1 Universal Service

Replacement Blower

MITW -12 / -15 Series

Step 20. If it has not already been done, remove the old vent adapter from the existing vent pipe.

Step 21. If necessary, re-route the vent pipe such that it can be properly seated in the top portion of the vent adapter.

Step 22. Be sure that both clamps on the vent adapter are firmly tightened, securing the blower, vent adapter, and vent pipe together.

Step 23. Double-check all vent connections.

Step 24. Restore electrical power to the water heater.

Step 25. On the water heater’s gas control, turn the power switch to the “On” position.

Plug power cord back into outlet.

Turn switch on gas valve to “On” position.

Warning:

Check all safety devices to make sure they

 

are working properly. Improper water heater

 

operation could occur if these devices are not

 

functioning properly.

 

 

Page 20

Page 19 Page 21
Image 20
Page 19 Page 21
Contents Instructions for Model Numbers Reference Kit Components Tools Required Bradford White TTW1 Universal Service Replacement Blower Step Remove the screws, qty , that secure Inside the access compartment, follow Just below the crimp connector, cut Plug both the blower Check all safety devices to make sure they Unplug the water heater from wall outlet Mitw -12 / -15 Series Place template on top of water heater in correct orientation TTW1 Universal Service Replacement Blower Secure Cover Screws Blower screws TTW1 Universal Service Replacement Blower Do not over tighten 2 screws attaching Tighten 2 screws on junction Box to secure cover Operation could occur if these devices are not M1TW60T*FCX TTW1 Universal Service Replacement Blower TTW1 Universal Service Replacement Blower Secure Cover screws Boot back Place Secure 3 blower screws Step If the new adapter is used, remove the old
Top Page Image Contents