Clutch Handle | Clutch Casting | Cable Counter |
| ||
|
|
Guard
FOR/OFF/REV
Switch
Latch (2)
| Guide Hose |
Motor Table |
|
Ratchet Knob | Engine/Generator |
| |
| Gear Motor Plug |
Drive Motor | Rear Wheel |
| |
| Front Wheel (2) |
Figure 3 – K-2000 Machine with Cable Guide Hose and Clutch Handle in Clutch Casting
WARNING
Never change power drive chain from one sprocket to the other with engine/generator running.
Figure 2 – Power Drive Chain on Large Sprocket
6.Pull ratchet knob again to drop motor table into po- sition, making sure chain slack is taken up. Put ratchet knob in LOCK POSITION.
7.Put machine guard back in place.
8.Screw clutch handle (Figure 3) into clutch casting.
9.Attach cable guide hose (Figure 3).
NOTE! If inlet is not a manhole, disregard steps 10 through 12.
10.Set telescoping manhole guide pipe (Figure 4) for depth of manhole. Place turnbuckle into manhole opening.
11.Insert first cable through manhole guide pipe and at- tach tool.
12.Put guide pipe into manhole and secure with “J” bolt to turnbuckle of guide pipe.
13.Attach next length of cable and feed from front through machine and through rear guide hose.
Turnbuckle
No.
Manhole Guide Pipe
Manhole
Figure 4 – Telescoping Manhole Guide Pipe
Ridge Tool Company • Elyria, Ohio • U.S.A. | 5 |