| EchoLife HG612 FTTC VDSL NTE |
3 Getting Started | User Guide |
Note
zThe name of this PVC should begin with atm.
zThe DSL link type of this ATM PVC should be EoA.
3.Select Enable for WAN connection.
4.Select a service from the Service list
5.Set Port binding to LAN1 or LAN2.
6.Select Route from the Connection mode
7.Set Connection type to PPPoE.
8.Select Enable for WAN802.1q, WAN802.1p, LAN802.1q, LAN802.1p, or NAT as required.
9.Enter the user name and password provided by the ISP.
10.Select Enable for DHCP spoofing as required.
11.Select the authentication mode provided by the ISP.
12.Select a dialing method, and then click Submit.
Step 3 Set LAN parameters.
1.In the navigation tree, choose Basic > LAN.
2.Set the IP address and subnet mask of the LAN connection.
3.Select Enable for DHCP server, and then set the corresponding parameters.
4.Click Submit.
3.4.5Configuring the ATM Bridge
Step 1 Configure the ATM PVC.
1.In the navigation tree, choose Basic > ATM.
2.Enter VPI/VCI provided by the ISP.
3.Set DSL link type to EoA.
4.Click Submit.
Step 2 Set WAN parameters.
1.In the navigation tree, choose Basic > WAN.
2.Select a PVC from the Layer2 interface
Note
zThe name of this PVC should begin with atm.
zThe DSL link type of this ATM PVC should be EoA.
3.Select Enable for WAN connection.
4.Select a service from the Service list
5.Set Port binding to LAN1 or LAN2.
6.Select Bridge from the Connection mode
7.Select PPPoE_ Bridged or IP_ Bridged from the Bridge type
8.Select Enable for DHCP transparent transmission, WAN802.1q, WAN802.1p, LAN802.1q, or LAN802.1p as required.
9.Click Submit.
Huawei Proprietary and Confidential | Issue 01 | ||
Copyright © Huawei Technologies Co., Ltd | |||
|
|