GE 263, 268 manual Display Icons

Page 23

Display Icons

Figure 9

9

10

		PM
		MIN
		LBS
		KG
		x100
7	6	8
	6

1

4

2

3

4

5

NOTE: In normal operation and during programming, only a few of the icons will actually be displayed.

1.Displays amount of conditioning capacity remaining.

2."PM" indicates that the time displayed is between 12:00 noon and 12:00 midnight (there is no AM indicator). PM indicator is not used if clock mode is set to 24-hour.

3.When "MIN" is displayed, the value entered is in minute increments.

4.When "LBS" is displayed, the value entered is in pounds.

5.When "Kg" is displayed, the value entered is in kilograms or kilograins.

6.Four digits used to display the time or program value. Also used for error codes.

7.Colon flashes as part of the time display. Indicates normal operation.

8.X100 multiplier for large values.

9.Shows when water is flowing through the valve.

10.Banner display.

Display Icons	23
	Rev A

Image 23

Contents Operations Manual Table of Contents Icons That Appear In This Manual Introduction How To Use This ManualMechanical General Warnings And Safety InformationElectrical General System Operation Cycle Functions Cycle Water Flows Equipment Installation Valve Layout Ultramax Controller Control LayoutOutdoor Locations Location SelectionLocation Selection Rev a Water Line Connection Water Line Connection Rev a Drain Line Connection Drain LineNot used with 3-cycle filter system Regenerant Line ConnectionOverflow Line Connection Overflow Line Connection Rev a AC Adapter Input Application Part Number Electrical ConnectionVAC AC Adapters Controller LocationValve Camshaft 25% Sodium Hypochlorite Disinfection Of Water ConditionersValve Disc Operation Sodium or Calcium Hypochlorite ApplicationCalcium Hypochlorite Controller Memory Power Loss Memory RetentionUltramax Controller MotorDisplay Icons Programming Conventions Keypad ButtonsThings You Might Need to Know Level I Programming Setting Time of DayProgramming Overview Setting Regeneration Time Setting Day of WeekFilter Operation Type Setting the Calendar OverrideLevel II Programming Conditioner Operation TypeSetting the Hardness conditioner only Setting Backwash Days 263 filter onlySetting the Salt Amount 268 softener only Setting Capacity Softener Default Capacity SettingViewing the Injector Type Setting Clock ModeSetting Units of Measure Adjusting the Cycle Times Conditioner Cycle TimesOperation Type Setting the Service IntervalSetting the Chlorine Generator/Salt Check conditioner only Total Water Used GAL X 100a Months Since SERVICEaLevel III Programming Peak Flow Rate GPMaFunction Display Text Placing Conditioner Into OperationConditioner and Filter Start-Up SET Action Key Duration DisplayRev a Performa Exploded View Part Code Description Qty Performa Parts ListProblem Possible Cause Solution TroubleshootingUltramax Series Controller Troubleshooting System Troubleshooting Intermittent or Low water pressure Rev a Controller Reset UltraMax System Configurations