GE 268, 263 manual Electrical Connection, VAC AC Adapters, Controller Location

Page 18

Electrical Connection

All Ultramax controllers operate on 12-volt alternating current power supply. This requires use of the GE Water Technologies supplied AC adapter. A variety of AC adapters are available for different applications. These AC adapters are available from your supplier. They include:

	AC Adapter	Input	Application	Part Number
	AC Adapter	Voltage	Application	Part Number
		Voltage


	Standard wall-mount	120V 60Hz	Standard indoor	1000811
	AC adapter		application

	Outdoor rated AC	120V 60Hz	UL listed for	1235448
	adapter		outdoor
			installations

120 VAC AC Adapters:

Make sure power source matches the rating printed on the AC adapter.

NOTE: The power source should be constant. Be certain the AC adapter is not on a switched outlet. Power interruptions longer than 8 hours may cause the controller to lose the time and day settings. When power is restored, the day and time settings must then be re-entered.

Controller Location

The Ultramax controllers are designed to be mounted on the valve or attached to a flat surface. Installations that do not provide easy access to the valve can have the controller mounted for remote operation.

A remote mount connection, PN 1256257, is available for the Ultramax Series controller.

18	Electrical Connection
Rev A

Image 18

Contents Operations Manual Table of Contents How To Use This Manual Icons That Appear In This Manual IntroductionGeneral Warnings And Safety Information ElectricalMechanical General System Operation Cycle Functions Cycle Water Flows Equipment Installation Valve Layout Control Layout Ultramax ControllerLocation Selection Outdoor LocationsLocation Selection Rev a Water Line Connection Water Line Connection Rev a Drain Line Drain Line ConnectionRegenerant Line Connection Not used with 3-cycle filter systemOverflow Line Connection Overflow Line Connection Rev a Controller Location Electrical ConnectionVAC AC Adapters AC Adapter Input Application Part NumberValve Camshaft Sodium or Calcium Hypochlorite Application Disinfection Of Water ConditionersValve Disc Operation 25% Sodium HypochloriteCalcium Hypochlorite Motor Power Loss Memory RetentionUltramax Controller Controller MemoryDisplay Icons Keypad Buttons Programming ConventionsThings You Might Need to Know Setting Time of Day Programming OverviewLevel I Programming Setting Day of Week Setting Regeneration TimeConditioner Operation Type Setting the Calendar OverrideLevel II Programming Filter Operation TypeSetting Capacity Softener Default Capacity Setting Setting Backwash Days 263 filter onlySetting the Salt Amount 268 softener only Setting the Hardness conditioner onlyAdjusting the Cycle Times Conditioner Cycle Times Setting Clock ModeSetting Units of Measure Viewing the Injector TypeSetting the Service Interval Operation TypeSetting the Chlorine Generator/Salt Check conditioner only Peak Flow Rate GPMa Months Since SERVICEaLevel III Programming Total Water Used GAL X 100aPlacing Conditioner Into Operation Conditioner and Filter Start-UpFunction Display Text Action Key Duration Display SETRev a Performa Exploded View Performa Parts List Part Code Description QtyTroubleshooting Ultramax Series Controller TroubleshootingProblem Possible Cause Solution System Troubleshooting Intermittent or Low water pressure Rev a UltraMax System Configurations Controller Reset