GE 263, 268 manual Valve Camshaft

Page 19

Valve Camshaft

Figure 7

Camshaft Front End for 263 and 268 valve bodies

The front end of the camshaft has an indicator cup. The cup has slots in the outer periphery and numbers on the inside face (Figure 7).

The numbers can be seen with the cover off, from the front over the top of the controller. The number at the top indicates which regeneration cycle is currently in progress.

Treated Water Indicator (normal operation)

Treated Water Slot

The corresponding slot for the number is positioned at the optical sensor which is approximately 90 degrees out of phase.

Regeneration Cycle Indicators

0= Treated Water - normal operation mode

1= Backwash Cycle

2= Regenerant Draw Cycle (not used in filter mode)

3= Slow Rinse Cycle (not used in filter mode)

4= System Pause

5= Fast Rinse Cycle 1

6= Backwash Cycle 2 (not used in filter mode)

7= Fast Rinse Cycle 2 (not used in filter mode)

8= Regenerant Refill (not used in filter mode)

Valve Camshaft	19
	Rev A

Image 19

Contents Operations Manual Table of Contents Icons That Appear In This Manual Introduction How To Use This ManualElectrical General Warnings And Safety InformationMechanical General System Operation Cycle Functions Cycle Water Flows Equipment Installation Valve Layout Ultramax Controller Control LayoutOutdoor Locations Location SelectionLocation Selection Rev a Water Line Connection Water Line Connection Rev a Drain Line Connection Drain LineNot used with 3-cycle filter system Regenerant Line ConnectionOverflow Line Connection Overflow Line Connection Rev a AC Adapter Input Application Part Number Electrical ConnectionVAC AC Adapters Controller LocationValve Camshaft 25% Sodium Hypochlorite Disinfection Of Water ConditionersValve Disc Operation Sodium or Calcium Hypochlorite ApplicationCalcium Hypochlorite Controller Memory Power Loss Memory RetentionUltramax Controller MotorDisplay Icons Programming Conventions Keypad ButtonsThings You Might Need to Know Programming Overview Setting Time of DayLevel I Programming Setting Regeneration Time Setting Day of WeekFilter Operation Type Setting the Calendar OverrideLevel II Programming Conditioner Operation TypeSetting the Hardness conditioner only Setting Backwash Days 263 filter onlySetting the Salt Amount 268 softener only Setting Capacity Softener Default Capacity SettingViewing the Injector Type Setting Clock ModeSetting Units of Measure Adjusting the Cycle Times Conditioner Cycle TimesOperation Type Setting the Service IntervalSetting the Chlorine Generator/Salt Check conditioner only Total Water Used GAL X 100a Months Since SERVICEaLevel III Programming Peak Flow Rate GPMaConditioner and Filter Start-Up Placing Conditioner Into OperationFunction Display Text SET Action Key Duration DisplayRev a Performa Exploded View Part Code Description Qty Performa Parts ListUltramax Series Controller Troubleshooting TroubleshootingProblem Possible Cause Solution System Troubleshooting Intermittent or Low water pressure Rev a Controller Reset UltraMax System Configurations