Argosy Research H-125 Series owner manual Wrench

Page 29

Order No: 15-V3007-12

Description: IC 2.0 Fitting 3/4” Brass SharkBite Assembly

ITEM NO.	ORDER NO.	DESCRIPTION	QTY.
1	15-V3151	Nut 1” Quick Connect	2
2	15-V3150	Split Ring	2
3	15-V3105	O-Ring 215	2
4	15-V3628	Fitting 3/4” Brass SharkBite	2

Order No: 15-V3007-13

Description: IC 2.0 Fitting 1” Brass SharkBite Assembly

ITEM NO.	ORDER NO.	DESCRIPTION	QTY.
1	15-V3151	Nut 1” Quick Connect	2
2	15-V3150	Split Ring	2
3	15-V3105	O-Ring 215	2
4	15-V3629	Fitting 1” Brass SharkBite	2

The nuts and caps are designed to be unscrewed or tightened by hand or with the special plastic wrench. If necessary a pliers can be used to unscrew the nut or cap. Do not use a pipe wrench to tighten or loosen nuts or caps. Do not place screwdriver in slots on caps and/or tap with a hammer.

Do not use pipe dope or other sealants on threads. Teflon tape must be used on threads of the 1” NPT connection and on the threads for the drain line connection. Teflon tape is not necessary on the nut connection nor caps because of o-ring seals.

Wrench

Although no tools are necessary to assemble or disassemble the valve, the wrench (shown in various positions on the valve) may be purchased to aid in assembly or disassembly. Wrench part number is 15-V3193-02.

29

Image 29

Contents With HP Electronics Table of Contents On TimeRelay Job Specification SheetOperating Conditions Soft Water BasicsBypass valve Operation Pre-Installation Check ListInstallation Instructions 650 User displays/settings635 Programming635PM Installer DISPLAYS/SETTINGS20 GR SET Time of DAYSoftener setup Cycle time adjustments800 MIN SET 12000 MIN6000 MIN MIN300 MIN 001 MINSET Regengal Service Reminder342 GAL DiagnosticsReset Diagnostic Values Hold Valve History 175 x1KBrine Reclaim Cycle Sequence800MIN EnabledOFF Miscellaneous Water Softener Draining ProcedureWater Softener Disinfection Cause Correction Trouble ShootingTrouble Shooting Problem Cause Relay troubleshootingDescription Qty H125 conditioner & salt keeper assembliesTank Assy Mineral Tank Distributor AssyDrawing no Order no Description Quantity Front Cover and Drive AssemblyInjector CAP, Injector SCREEN, INJECTOR, Plug and O-RING Spacer Stack AssemblyProper flow Drain line Drain line 3/4Bypass valve Water meter and meter plugInstallation fitting assemblies Wrench Flow Diagrams Service and Backwash Flow Diagrams Downflow Flow Diagrams Rinse and Fill Factory Regeneration Settings H125 SpecificationsProgramming options General specificationsResults Reserve capacity estimate based on history of water usageService Instructions Compliance Table Spacer Stack AssemblyRefill Flow Control Assembly or Refill Port Plug Page Page H125 Series Water Softeners Limited warranty