Job Specification Sheet
MODEL NO. __________________________________________________________________________________________
*WATER TEST AT TIME OF INSTALLATION |
|
| ||
_______ Hardness CaCo3 (gpg) | ______ Other______________________ |
| ||
_______ Iron (ppm) |
| ______ Other______________________ |
| |
_______ pH |
| ______ Other______________________ |
| |
______ Reclamation mode enabled |
|
|
| |
______ No Hard |
|
|
| |
______ Alternator system enabled |
|
|
| |
OPTIONAL RELAY SETTINGS |
|
|
| |
_______ Off |
|
|
|
|
Relay 1 |
| Relay 2 |
|
|
_______ On TimeRelay 1 | Set Point | _______ On TimeRelay 2 | Set Point | |
_______Start Time, Minutes into Regeneration | _______Start Time, Minutes into Regeneration | |||
Relay 1 | Duration |
| Relay 2 | Duration |
_______Run Time |
| _______Run Time | ||
_______ On Gallons |
| _______ On Gallons |
| |
Relay 1 | Set Point |
| Relay 2 | Set Point |
Pulse per _______ Gallons |
| Pulse per _______ Gallons | ||
Relay 1 | Duration |
| Relay 2 | Duration |
_______ Minutes Relay Closed |
| _______ Minutes Relay Closed | ||
Relay 1 | Set Point |
| Relay 2 | Set Point |
_______ On Regen Gallons | _______ On Regen Gallons | |||
Relay 1 | Set Point |
| Relay 2 | Set Point |
Pulse per _______ Gallons |
| Pulse per _______ Gallons | ||
Relay 1 | Duration |
| Relay2 Duration | |
_______ Minutes Relay Closed |
| _______ Minutes Relay Closed | ||
Relay 1 | Set Point |
| Relay 2 | Set Point |
|
|
|
|
|
*SIZING INFORMATION |
|
|
|
|
All Water is Softened Except: |
|
|
| |
_______ Rear Hose Bib | _______ Front Hose Bib _______ Kitchen Cold | _______ Toilets _______ All Cold | ||
_______ Other ________________________________________________________________________________________
The average family uses 75 gallons per person daily for all water uses in the home, about 50 gallons per person daily if soft water is not supplied to the toilets, and about 30 gallons per person daily if only hot water is softened.
_______ Daily Water Usage (Gallons/Person)
x_______ Family Size (Number of people in family) = _______ Total Gallons Per Day
x_______ Grains Per Gallon of Hardness
(Note: Add 3 grains per gallon of hardness for each ppm iron for total compensated hardness) = _______ Total Grains Per Day
*INSTALLATION DATE _________________________________________________________________________________
*SERIAL NUMBER ____________________________________________________________________________________
NOTES ______________________________________________________________________________________________
3