Briggs & Stratton 073000 Maintenance Schedule, General Recommendations, Emissions Control

MAINTENANCE

MAINTENANCE SCHEDULE

Follow the hourly or calendar intervals, whichever occurs first.

More frequent service is required when operating in adverse conditions noted below.

MAINTENANCE SCHEDULE
FILL IN DATES AS YOU		SERVICE DATES
COMPLETE REGULAR SERVICE				SERVICE DATES
MAINTENANCE TASK	Before Each	Every 8 Hours	Every 50 Hours
	Use	or Yearly	or Yearly
Clean debris	X
Check oil level	X
Change engine oil		X
Service air cleaner		X
Service spark plug			X
Prepare for storage	If unit is to remain idle for longer than 30 days.

Change oil after the first (4) operating hours and every 8 hours or every year, whichever occurs first, thereafter. Change oil every 4 hours when operating under heavy loads or in high temperatures.

Clean more often under dusty conditions or when airborne debris is present. Replace air cleaner if very dirty.

General Recommendations

Regular maintenance will improve the performance and extend the life of the water pump. We recommend you use an authorized Briggs & Stratton service dealer for all maintenance and service. Use only genuine Briggs & Stratton parts.

The water pump’s warranty does not cover items that have been subjected to operator abuse or negligence. To receive full value from the warranty, the operator must maintain water pump as instructed in this manual.

All service and adjustments should be made at least once each season. Follow the requirements in the “Maintenance Schedule” chart above.

NOTE: Once a year you should clean or replace the spark plug and replace the air filter. A new spark plug and clean air filter assure proper fuel-air mixture and help your engine run better and last longer.

Emissions Control

Maintenance, replacement or repair of the emissions control devices and systems may be performed by any non-road engine repair establishment or individual. See emissions control system warranty, elsewhere in this manual.

Maintenance

Maintenance consists of keeping the water pump clean. Store the unit in a clean dry environment where it will not be exposed to excessive dust, dirt, moisture or any corrosive vapors. Cooling air slots in the water pumps engine must not become clogged with dirt, leaves or any other foreign material.

NOTE: DO NOT use a garden hose to clean water pumps engine. Water can enter engine fuel system and cause problems.

Cleaning

Daily or before use, look around and underneath water pump for signs of oil or fuel leaks. Clean accumulated debris from inside and outside water pump. Keep linkage, spring and other engine controls clean. Keep area around and behind muffler free from any combustible debris. Inspect cooling air slots and opening on water pump. These openings must be kept clean and unobstructed.

Engine parts should be kept clean to reduce the risk of overheating and ignition of accumulated debris.

•Use a damp cloth to wipe exterior surfaces clean.

•Use a soft bristle brush to loosen caked on dirt or oil.

•Use a vacuum cleaner to pick up loose dirt and debris.

14