Briggs & Stratton 073000 manuel dutilisation Starting the Water Pump, Primer Bulb

Page 11

OPERATION

Starting the Water Pump

Use the following start instructions:

1.Make sure unit is on a flat, level surface and pump chamber is primed.

2.Push primer bulb (Figure 14) 15 times for a new engine. Push primer bulb 8 times for all future starts.

Figure 14 — Primer Bulb

Primer Bulb

3.Move red choke lever to “Full Choke” () position (Figure 15).

Figure 15 — Choke Lever

Choke Lever shown in “Full Choke” position

4. Move throttle lever all the way up (Figure 16).

Figure 16 — Throttle Lever

Throttle Lever

shown fully up

5.While firmly grasping pump carrying handle with left hand, pull starter handle with right hand slowly until slight resistance is felt. Then pull handle rapidly to overcome compression, prevent kickback and start engine.

WARNING

Rapid retraction of starter cord (kickback) will pull hand and arm toward engine faster than you can let go.

Broken bones, fractures, bruises or sprains could result.

•When starting engine, pull cord slowly until resistance is felt and then pull rapidly to avoid kickback.

IMPORTANT: If excessive fuel is present in the air/fuel mixture causing a “flooded” condition, move choke lever to “Off Choke” () position and pull handle repeatedly until engine starts.

6. Wait a maximum of 10 seconds, then move choke lever to “Half Choke” ( ) position.

7.Run the engine at “Half Choke” for 20 seconds or until unit accelerates smoothly. Move choke lever to “Off Choke” () position.

IMPORTANT: It may take a few minutes for water pump to begin pumping water.

WARNING

Running engines produce heat. Temperature of muffler and nearby areas can reach or exceed 150°F (65°C).

Severe burns can occur on contact.

Exhaust heat/gases can ignite combustibles, structures or damage fuel tank causing a fire.

•DO NOT touch hot surfaces and avoid hot exhaust gases.

•Allow equipment to cool before touching.

•Keep at least 5 ft. (152 cm) clearance on all sides of water pump including overhead.

•Code of Federal Regulation (CFR) Title 36 Parks, Forests, and Public Property require equipment powered by an internal combustion engine to have a spark arrester, maintained in effective working order, complying to USDA Forest service standard 5100-1C or later revision. In the State of California a spark arrester is required under section 4442 of the California Public resources code. Other states may have similar laws.

Pump output is controlled by adjusting engine speed. Moving the throttle lever up will increase pump output, and moving the throttle lever down will decrease pump output.

11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Call Helpline Appelez Ligne dassistance Llame Línea Directa 073000Equipment Description Table of ContentsSafety Rules When Starting Equipment When Adjusting or Making Repairs to Your Water PumpWhen Testing for Engine Spark When Adding or Draining FuelSafety Rules Know Your Water Pump Add Engine Oil AssemblyCarton Contents Unpack Water PumpConnect Suction Hose to Pump Connect Suction HoseType of Fuel High-altitude useConnect Suction Hose to Strainer Basket Discharge Hose AssemblyGarden Hose Discharge Assembly Connect Discharge Hose OptionalMove Water Pump to Safe Operating Location Using the Water PumpWhat is Head? Safe Operating ConsiderationsLocate Strainer Basket Into Water Source Prime the Water PumpPrimer Bulb Starting the Water PumpDrain and Flush Water Pump Stopping the Water PumpModel Product SpecificationsPower Ratings Engine Technical InformationGeneral Recommendations Maintenance ScheduleMaintenance CleaningAdding Engine Oil OilOil Recommendations Checking Oil LevelDrain Oil Changing Engine OilTo service the air cleaner, follow these steps Service Air CleanerService Spark Plug Water Pump StorageLong Term Storage Instructions Protect Fuel SystemProblem Cause Correction TroubleshootingPage Owner’s Warranty Responsibilities Emissions Control System WarrantyEmissions Information Limited Warranty Warranty PeriodRègles DE Sécurité Table DES MatièresDescription DE Léquipement Mise EN GardeLors DU Démarrage DE Léquipement Lors DU Réglage OU DES Réparations DE Votre Pompe À EAULors DE Tests Dallumage DU Moteur Lors DE Lajout OU DE LA Vidange DU CarburantAvertissement Connaître Votre Pompe À EAU Ajout de lhuile à moteur AssemblageDéballage de la pompe à eau Contenu de la boîteBranchement du boyau daspiration à la pompe Fixation du boyau daspirationType d’essence Utilisation à hautes altitudesMontage du tuyau d’arrosage d’évacuation Branchement du boyau dévacuation facultatifFixation du boyau daspiration au panier-filtre Boyau d’évacuation de 2,5 cm 1 poDégagements et mouvement de lair Déplacement de la pompe vers un emplacement sécuritaireUtilisation DE LA Pompe À EAU Avertissement Pour un fonctionnement sécuritaireLocalisation du panier-filtre dans la source deau Amorçage de la pompe à eauPompe d’amorçage Démarrage de la pompe à eauVidange et rinçage de la pompe à eau Arrêt de la pompe à eauCaractéristiques de la pompe à eau Caractéristiques DU ProduitPuissance nominale ModèleEntretien Recommandations généralesCalendrier Dentretien Contrôle des émissionsAjout d’huile Recommandations relatives à l’huileHuile Vérification du niveau d’huileLors DU Réglage OU DES Réparations DE Votre Pompe À EAU Changement d’huilePour faire lentretien du filtre à air, procédez comme suit Entretien du filtre à airEntretien de la bougie dallumage Autres conseils dentreposage EntreposageDirectives dentreposage à long terme Pompe à eauDépannage Problèm Cause SolutionRemarques Garantie DU Dispositif Antipollution Renseignements sur les émissions Garantie Limitée Période DE GarantieNormas DE Seguridad ÍndiceDescripción DEL Equipo PrecauciónCuando Ponga EN Funcionamiento EL Equipo Cuando Ajuste O Repare LA Bomba DE AguaCuando Pruebe LA Bujía DEL Motor Cuando Añada Combustible O Vacíe EL DepósitoAdvertencia Conozca SU Bomba DE Agua Añadir aceite del motor MontajeDesembalaje de la bomba de agua Contenido de la cajaConexión de la manguera de aspiración a la bomba Fijación de la manguera de aspiraciónTipo de combustible Uso en grandes altitudesDescarga con manguera de riego Conexión de la manguera de descarga opcionalConexión de la manguera a la cesta del filtro Manguera de descarga deEspacio libre y circulación de aire USO DE LA Bomba DE Agua AdvertenciaConsideraciones para un uso seguro Colocación de la bomba de agua en una posición seguraColocación de la cesta del filtro en la fuente de agua Cebado de la bomba de aguaChoke Puesta en marcha de la bomba de aguaVaciado y limpieza de la bomba de agua Parada de la bomba de aguaModelo Información Técnica Sobre EL MotorEspecificaciones DEL Producto Potencia nominalMantenimiento Plan DE MantenimientoRecomendaciones generales Control de emisionesAdición de aceite del motor AceiteRecomendaciones sobre el aceite Comprobación del nivel de aceiteCuando Ajuste O Repare LA Bomba DE Agua Cambio del aceite del motorPara revisar el filtro de aire, siga estos pasos Revisión del filtro de aireRevisión de la bujía Bomba de agua AlmacenamientoInstrucciones de almacenamiento a largo plazo Proteja el Sistema de CombustibleProblema Motivo Solución Resolución DE ProblemasNotas Notas Garantía DEL Sistema DE Control DE Emisiones Información sobre emisiones Garantía Limitada

073000 specifications

The Briggs & Stratton 073000 is a powerful and versatile small engine that caters to a wide range of outdoor applications, including lawn mowers, pressure washers, and various garden tools. Known for its reliability and efficiency, this engine has become a trusted choice for DIY enthusiasts and professional landscapers alike.

One of the primary features of the Briggs & Stratton 073000 is its durable construction. Designed with robust materials, the engine can withstand the rigors of outdoor use, ensuring a long service life. The design includes a heavy-duty crankshaft and cast-iron cylinder sleeve, which contribute to its excellent performance and reduced wear over time.

Power output is a key characteristic of the 073000, providing ample torque to tackle tough tasks. The engine typically delivers around 6.75 to 7.25 foot-pounds of torque, making it suitable for various applications without compromising on performance. Moreover, its compact size allows for easy installation and adaptability to different types of equipment.

Another significant aspect of the Briggs & Stratton 073000 is its innovative technologies aimed at enhancing efficiency and user experience. The engine features an advanced air filtration system, which helps keep the internal components clean and reduces maintenance intervals. This ensures that the engine operates at peak performance for longer periods.

Starting the engine is made easy with the inclusion of a reliable recoil start mechanism. This system is designed for smooth operation, allowing users to start the engine effortlessly, even in challenging conditions. Additionally, the engine’s low oil shutdown technology helps protect it from damage by automatically shutting off when the oil level is low.

Another appealing characteristic is the engine's sound level. Briggs & Stratton has engineered the 073000 to operate quietly, significantly reducing noise pollution during operation. This feature is particularly advantageous for residential areas where noise restrictions may apply.

Overall, the Briggs & Stratton 073000 combines power, efficiency, and durability in a compact package. With features geared towards optimum performance and ease of use, this engine is an excellent choice for anyone looking to power their outdoor equipment reliably. Its reputation for quality and performance continues to make it a popular option among consumers and professionals alike.
Top Page Image Contents