Briggs & Stratton 073000 Emissions Control System Warranty, Owner’s Warranty Responsibilities

Page 21

EMISSIONS CONTROL SYSTEM WARRANTY

Briggs & Stratton Corporation (B&S), the California Air Resources Board (CARB)

and the United States Environmental Protection Agency (U.S. EPA)

Emissions Control System Warranty Statement

(Owner’s Defect Warranty Rights and Obligations)

California, United States and Canada Emissions Control Defects Warranty Statement

The California Air Resources Board (CARB), U.S. EPA and B&S are pleased to explain the Emissions Control System Warranty on your small off–road engine (SORE). In California, new small off–road engines model year 2006 and later must be designed, built and equipped to meet the State’s stringent anti–smog standards. Elsewhere in the United States, new non–road, spark–ignition engines certified for model year 1997 and later must meet similar standards set forth by the U.S. EPA. B&S must warrant the emissions control system on your engine for the periods of time listed below, provided there has been no abuse, neglect or improper maintenance of your small off–road engine.

Your emissions control system includes parts such as the carburetor, air cleaner, ignition system, fuel line, muffler and catalytic converter. Also included may be connectors and other emissions related assemblies.

Where a warrantable condition exists, B&S will repair your small off–road engine at no cost to you including diagnosis, parts and labor.

Briggs & Stratton Emissions Control Defects Warranty Coverage

Small off–road engines are warranted relative to emissions control parts defects for a period of two years, subject to provisions set forth below. If any covered part on your engine is defective, the part will be repaired or replaced by B&S.

Owner’s Warranty Responsibilities

As the small off–road engine owner, you are responsible for the performance of the required maintenance listed in your Operating and Maintenance Instructions. B&S recommends that you retain all your receipts covering maintenance on your small off–road engine, but B&S cannot deny warranty solely for the lack of receipts or for your failure to ensure the performance of all scheduled maintenance.

As the small off–road engine owner, you should however be aware that B&S may deny you warranty coverage if your small off–road engine or a part has failed due to abuse, neglect, improper maintenance or unapproved modifications.

You are responsible for presenting your small off–road engine to an Authorized B&S Service Dealer as soon as a problem exists. The undisputed warranty repairs should be completed in a reasonable amount of time, not to exceed 30 days.

If you have any questions regarding your warranty rights and responsibilities, you should contact a B&S Service Representative at 1–414–259–5262.

The emissions warranty is a defects warranty. Defects are judged on normal engine performance. The warranty is not related to an in–use emissions test.

Briggs & Stratton Emissions Control Defects Warranty Provisions

The following are specific provisions relative to your Emissions Control Defects Warranty Coverage. It is in addition to the B&S engine warranty for non–regulated engines found in the Operator’s Manual.

1.Warranted Parts

Coverage under this warranty extends only to the parts listed below (the emissions control systems parts) to the extent these parts were present on the engine purchased.

a.Fuel Metering System

Cold start enrichment system (soft choke)

Carburetor and internal parts

Fuel Pump

Fuel line, fuel line fittings, clamps

b.Air Induction System

• Air cleaner

• Intake manifold

c.Ignition System

Spark plug(s)

Magneto ignition system

d.Catalyst System

Catalytic converter

Exhaust manifold

Air injection system or pulse valve

e.Miscellaneous Items Used in Above Systems

Vacuum, temperature, position, time sensitive valves and switches

Connectors and assemblies

2.Length of Coverage

B&S warrants to the initial owner and each subsequent purchaser that the Warranted Parts shall be free from defects in materials and workmanship which caused the failure of the Warranted Parts for a period of two years from the date the engine is delivered to a retail purchaser.

3.No Charge

Repair or replacement of any Warranted Part will be performed at no charge to the owner, including diagnostic labor which leads to the determination that a Warranted Part is defective, if the diagnostic work is performed at an Authorized B&S Service Dealer. For emissions warranty service contact your nearest Authorized B&S Service Dealer as listed in the “Yellow Pages” under “Engines, Gasoline,” “Gasoline Engines,” “Lawn Mowers,” or similar category.

4.Claims and Coverage Exclusions

Warranty claims shall be filed in accordance with the provisions of the B&S Engine Warranty Policy. Warranty coverage shall be excluded for failures of Warranted Parts which are not original B&S parts or because of abuse, neglect or improper maintenance as set forth in the B&S Engine Warranty Policy. B&S is not liable to cover failures of Warranted Parts caused by the use of add–on, non–original, or modified parts.

5.Maintenance

Any Warranted Part which is not scheduled for replacement as required maintenance or which is scheduled only for regular inspection to the effect of “repair or replace as necessary” shall be warranted as to defects for the warranty period. Any Warranted Part which is scheduled for replacement as required maintenance shall be warranted as to defects only for the period of time up to the first scheduled replacement for that part. Any replacement part that is equivalent in performance and durability may be used in the performance of any maintenance or repairs. The owner is responsible for the performance of all required maintenance, as defined in the B&S Operator’s Manual.

6.Consequential Coverage

Coverage hereunder shall extend to the failure of any engine components caused by the failure of any Warranted Part still under warranty.

Image 21
Contents Call Helpline Appelez Ligne dassistance Llame Línea Directa 073000Table of Contents Safety RulesEquipment Description When Testing for Engine Spark When Adjusting or Making Repairs to Your Water PumpWhen Adding or Draining Fuel When Starting EquipmentSafety Rules Know Your Water Pump Carton Contents AssemblyUnpack Water Pump Add Engine OilType of Fuel Connect Suction HoseHigh-altitude use Connect Suction Hose to PumpGarden Hose Discharge Assembly Discharge Hose AssemblyConnect Discharge Hose Optional Connect Suction Hose to Strainer BasketWhat is Head? Using the Water PumpSafe Operating Considerations Move Water Pump to Safe Operating LocationLocate Strainer Basket Into Water Source Prime the Water PumpPrimer Bulb Starting the Water PumpDrain and Flush Water Pump Stopping the Water PumpPower Ratings Product SpecificationsEngine Technical Information ModelMaintenance Maintenance ScheduleCleaning General RecommendationsOil Recommendations OilChecking Oil Level Adding Engine OilDrain Oil Changing Engine OilService Air Cleaner Service Spark PlugTo service the air cleaner, follow these steps Long Term Storage Instructions StorageProtect Fuel System Water PumpProblem Cause Correction TroubleshootingPage Owner’s Warranty Responsibilities Emissions Control System WarrantyEmissions Information Limited Warranty Warranty PeriodDescription DE Léquipement Table DES MatièresMise EN Garde Règles DE SécuritéLors DE Tests Dallumage DU Moteur Lors DU Réglage OU DES Réparations DE Votre Pompe À EAULors DE Lajout OU DE LA Vidange DU Carburant Lors DU Démarrage DE LéquipementAvertissement Connaître Votre Pompe À EAU Déballage de la pompe à eau AssemblageContenu de la boîte Ajout de lhuile à moteurType d’essence Fixation du boyau daspirationUtilisation à hautes altitudes Branchement du boyau daspiration à la pompeFixation du boyau daspiration au panier-filtre Branchement du boyau dévacuation facultatifBoyau d’évacuation de 2,5 cm 1 po Montage du tuyau d’arrosage d’évacuationUtilisation DE LA Pompe À EAU Avertissement Déplacement de la pompe vers un emplacement sécuritairePour un fonctionnement sécuritaire Dégagements et mouvement de lairLocalisation du panier-filtre dans la source deau Amorçage de la pompe à eauPompe d’amorçage Démarrage de la pompe à eauVidange et rinçage de la pompe à eau Arrêt de la pompe à eauPuissance nominale Caractéristiques DU ProduitModèle Caractéristiques de la pompe à eauCalendrier Dentretien Recommandations généralesContrôle des émissions EntretienHuile Recommandations relatives à l’huileVérification du niveau d’huile Ajout d’huileLors DU Réglage OU DES Réparations DE Votre Pompe À EAU Changement d’huileEntretien du filtre à air Entretien de la bougie dallumagePour faire lentretien du filtre à air, procédez comme suit Directives dentreposage à long terme EntreposagePompe à eau Autres conseils dentreposageDépannage Problèm Cause SolutionRemarques Garantie DU Dispositif Antipollution Renseignements sur les émissions Garantie Limitée Période DE GarantieDescripción DEL Equipo ÍndicePrecaución Normas DE SeguridadCuando Pruebe LA Bujía DEL Motor Cuando Ajuste O Repare LA Bomba DE AguaCuando Añada Combustible O Vacíe EL Depósito Cuando Ponga EN Funcionamiento EL EquipoAdvertencia Conozca SU Bomba DE Agua Desembalaje de la bomba de agua MontajeContenido de la caja Añadir aceite del motorTipo de combustible Fijación de la manguera de aspiraciónUso en grandes altitudes Conexión de la manguera de aspiración a la bombaConexión de la manguera a la cesta del filtro Conexión de la manguera de descarga opcionalManguera de descarga de Descarga con manguera de riegoConsideraciones para un uso seguro USO DE LA Bomba DE Agua AdvertenciaColocación de la bomba de agua en una posición segura Espacio libre y circulación de aireColocación de la cesta del filtro en la fuente de agua Cebado de la bomba de aguaChoke Puesta en marcha de la bomba de aguaVaciado y limpieza de la bomba de agua Parada de la bomba de aguaEspecificaciones DEL Producto Información Técnica Sobre EL MotorPotencia nominal ModeloRecomendaciones generales Plan DE MantenimientoControl de emisiones MantenimientoRecomendaciones sobre el aceite AceiteComprobación del nivel de aceite Adición de aceite del motorCuando Ajuste O Repare LA Bomba DE Agua Cambio del aceite del motorRevisión del filtro de aire Revisión de la bujíaPara revisar el filtro de aire, siga estos pasos Instrucciones de almacenamiento a largo plazo AlmacenamientoProteja el Sistema de Combustible Bomba de aguaProblema Motivo Solución Resolución DE ProblemasNotas Notas Garantía DEL Sistema DE Control DE Emisiones Información sobre emisiones Garantía Limitada

073000 specifications

The Briggs & Stratton 073000 is a powerful and versatile small engine that caters to a wide range of outdoor applications, including lawn mowers, pressure washers, and various garden tools. Known for its reliability and efficiency, this engine has become a trusted choice for DIY enthusiasts and professional landscapers alike.

One of the primary features of the Briggs & Stratton 073000 is its durable construction. Designed with robust materials, the engine can withstand the rigors of outdoor use, ensuring a long service life. The design includes a heavy-duty crankshaft and cast-iron cylinder sleeve, which contribute to its excellent performance and reduced wear over time.

Power output is a key characteristic of the 073000, providing ample torque to tackle tough tasks. The engine typically delivers around 6.75 to 7.25 foot-pounds of torque, making it suitable for various applications without compromising on performance. Moreover, its compact size allows for easy installation and adaptability to different types of equipment.

Another significant aspect of the Briggs & Stratton 073000 is its innovative technologies aimed at enhancing efficiency and user experience. The engine features an advanced air filtration system, which helps keep the internal components clean and reduces maintenance intervals. This ensures that the engine operates at peak performance for longer periods.

Starting the engine is made easy with the inclusion of a reliable recoil start mechanism. This system is designed for smooth operation, allowing users to start the engine effortlessly, even in challenging conditions. Additionally, the engine’s low oil shutdown technology helps protect it from damage by automatically shutting off when the oil level is low.

Another appealing characteristic is the engine's sound level. Briggs & Stratton has engineered the 073000 to operate quietly, significantly reducing noise pollution during operation. This feature is particularly advantageous for residential areas where noise restrictions may apply.

Overall, the Briggs & Stratton 073000 combines power, efficiency, and durability in a compact package. With features geared towards optimum performance and ease of use, this engine is an excellent choice for anyone looking to power their outdoor equipment reliably. Its reputation for quality and performance continues to make it a popular option among consumers and professionals alike.