Mitsubishi Electronics PCA-AGA, PLA-AAA, PKA-AGA Function Selection, Error Codes indication

7.Other Functions

7.2.Error Codes indication

ERROR CODE

ON/OFF

Indoor Unit’s Refrig- Error Code		Indoor Unit No.
erant Address
	Alternating Display
If you have entered contact number to be called in the event of a problem, the screen displays this number.
(You can set this up under Function Selection of remote controller. For information, refer to section 8.)

ON lamp (Flashing)

●If the ON lamp and error code are both flashing: This means that the air conditioner is out of order and operation has been stopped (and cannot resume). Take note of the indicated unit number and error code, then switch off the power to the air conditioner and call your dealer or servicer.

˚F

	When the Check button is pressed:
	CALL:XXXX
ERROR CODE	XXX:XXX
˚F
ON/OFF	ON/OFF

Error Code

●If only the error code is flashing (while the ON lamp remains lit): Operation is continuing, but there may be a problem with the system. In this case, you should note down the error code and then call your dealer or servicer for advice.

*If you have entered contact number to be called in the event of a problem, push the Check button to display it on the screen. (You can set this up under Function Selection of remote controller. For information, refer to section 8.)

8. Function Selection

Function selection of remote controller

The setting of the following remote controller functions can be changed using the remote controller function selection mode. Change the setting when needed.

Item 1		Item 2	Item 3 (Setting content)
1. Change Language	Language setting to display		• Display in multiple languages is possible
(“CHANGE
LANGUAGE”)
2. Function limit	(1)	Operation function limit setting (operation lock) (“LOCKING	• Setting the range of operation limit (operation lock)
(“FUNCTION		FUNCTION”)
SELECTION”)
	(2)	Use of automatic mode setting (“SELECT AUTO MODE”)	• Setting the use or non-use of “automatic” operation mode
	(3) Temperature range limit setting (“LIMIT TEMP FUNCTION”)		• Setting the temperature adjustable range (maximum, minimum)
3. Mode selection	(1)	Remote controller main/sub setting (“CONTROLLER MAIN/	• Selecting main or sub remote controller
		SUB”)	* When two remote controllers are connected to one group, one controller
(“MODE SELEC-
			must be set to sub.
TION”)
	(2)	Use of clock setting (“CLOCK”)	• Setting the use or non-use of clock function
	(3) Timer function setting (“WEEKLY TIMER”)		• Setting the timer type
	(4)	Contact number setting for error situation (“CALL.”)	• Contact number display in case of error
			• Setting the telephone number
4. Display change	(1) Temperature display °C/°F setting (“TEMP MODE °C/°F”)		• Setting the temperature unit (°C or °F) to display
(“DISP MODE
	(2)	Suction air temperature display setting (“ROOM TEMP DISP	• Setting the use or non-use of the display of indoor (suction) air tempera-
SETTING”)
		SELECT”)	ture
	(3)	Automatic cooling/heating display setting (“AUTO MODE	• Setting the use or non-use of the display of “Cooling” or “Heating” display
		DISP C/H”)	during operation with automatic mode

12