Mitsubishi Electronics SKM25ZD-S About Timer operation, About FAN Speed, Replacing the batteries

Page 14

About TIMER operation

About Amenity facilities

Amenity facilities enable to start the operation a little earlier, so that the room approaches optimum temperature at ON time when the operation is started by ON-TIMER.

Mechanism

The room temperature is checked

60 minutes before the timer is at

 

In COOL operation

 

 

 

 

 

ON. Depending on the tempera-

 

 

(Stop) Operation starts

ture at that time, the operation

 

 

 

 

 

 

 

starts 5 to 60 minutes before the

 

 

 

 

(Operation)

timer is at ON.

Set tem

per

ature

 

 

 

The Amenity facility only func-

 

 

 

 

 

 

 

 

 

 

tions for COOL and HEAT op-

 

 

 

 

 

 

 

eration mode (including AUTO).

 

 

 

 

 

 

 

 

Check the room

Set time

It does not work for DRY mode.

 

 

 

temp. 60 mins.

 

 

 

in advance.

About FAN SPEED

You can choose the capacity of your air conditioner when heating or cooling.

Operation capacity by your choice

FAN SPEED

Set automatically by microcomputer

AUTO

Powerful operation with high capacity

HI

Standard operation

MED

Energy-saving operation

LO

NOTE

When changing FAN SPEED from HI to LO, the sound of refrigerant flowing may be heard.

Remote control handling procedure

Replacing the batteries

The following cases signify exhausted batteries. Replace old batteries with new ones.

Receiving beep is not emitted when a signal is transmitted.

Indicator fades away.

1

 

When the indicator shows any abnormal condition, Press the reset

Remove back lid and take out old batteries.

switch with the tip of a ballpoint pen.

 

 

 

 

2

Insert new batteries. (SUM-4 or R03x2)

 

Attention to

the , and .

marks

NOTE

Don't use old and new batteries together.

Remove the batteries when the remote control is not used for a long period.

The life of a battery conforming to JIS or IEC is 6 to 12 months with normal use. If used longer, or when an unspecified battery is used, liquid may leak from the battery, causing the remote control to malfunction.

3 Close back lid.

On the battery is printed its expected life. This may be shorter than that of the air conditioner, depending on the date of manu- facture.

However, the battery may still be in working order after expiry of its nominal life.

– 13 –

Image 14
Contents USER’S Manual Contents Operation Precautions Safety precautionsInstallation Precautions Do not install near places where inflammable gas may leakDo not touch the aluminum fins on the air heat exchanger Precautions for Transfer or RepairsDo not sit on the outdoor unit nor put anything on it Choise of operations Choice of operations and featuresCharacteristics Outdoor Unit SCM45ZD-S SCM80ZD-S SCM60ZD-S Name of each part and its functionIndoor Unit Removal, installation of suction grill How to open the suction grillHow to close the suction grill Unit indication sectionIndication section Transmission procedureOperation section Auto mode operation procedure Temperature adjustment during AutoConcerning economy operation COOL/HEAT/DRY mode operation procedureConcerning high power operation Air scroll Air flow direction adjustment procedureEmergency run operation Swing FlapPresent time setting procedure OFF-TIMER operation procedureON-TIMER operation procedure Program Timer operation procedureAbout FAN Speed About Timer operationRemote control handling procedure Replacing the batteriesAvoid direct sunlight and draught Set a suitable room temperatureOperating hints During the operational season MaintenanceBefore maintenance At the end of the seasonFeature Color Has the unit been installed correctly?Suitable installation position Inspection and maintenanceAbout the Multiple Air-conditioner TroubleshootingRefrigerant oil recovery operation Simultaneous OperationPlease remember Air conditioner operating conditions When to contact your distributor without delayPower Blackout Auto Restart Function Page Inhalt Vorsorge IM Betrieb Vorsichtsmassnahmen BEI DER InstallationSicherheitsvorschriften Den Körper nicht längere Zeit dem Kühlluftstrom aussetzenScher nicht berühren VORSORGEMAßNAHMEN BEI Versetzung Oder ReparaturenDie Aluminiumrippen am Wärmetau Heit kontrollierenUnterschiedliche Betriebsarten KennzeichenAussengerät SCM45ZD-S SCM80ZD-S SCM60ZD-S Namen der Teile und ihre FunktionenInnengerät Schließen des Ansaugluftgitters AnzeigenteilÖffnen des Ansaugluftgitters ON/OFF Schalter des GerätesBedienungsteil ÜbermittlungTemperatureinstellung bei Auto Auto BetriebZür Betriebsart Economy Zür Betriebsart HI PowerCOOL/HEAT/DRY Betrieb Memory Flap Klappenstopp Einstellung der LuftströmungsrichtungNotbetrieb Betrieb des Ausschalttimers Verfahren zur Einstellung der aktuellen ZeitDie Taste Einschalttimer drücken Betrieb des EinschalttimersBetrieb des Programm-TIMERS Einstellung des EINSCHALTTIMER-BetriebsBatterien auswechseln Timer BetriebUmgang mit der Fernbedienung Beim Umgang mit der Fernbedienung folgendes beachten Wenn die Fernbedienung nicht funktioniertBetriebshinweise Einstellung der üblichen Raum Filter regelmäßig reinigenWährend der Betriebssaison WartungVor der Wartung Bei Ende der SaisonAchten Sie auf das Betriebsgeräusch Ist das Gerät einwandfrei installiert?Angemessene Installation Gegenstand Merkmal FarbeGleichzeitiger Betrieb Zur MehrfachklimaanlageFehlersuche Automatischer BetriebBitte beachten Betriebsbedingungen für die Klimaanlage Stromausfall-NeustartfunktionMechanismen und Leistung des Heat Betriebes Kennzeichen beim Heat BetriebSelbstdiagnose EntfrostungAIR-CONDITIONING & Refrigeration Systems Headquarters AIR-CONDITIONER Division