Emerson IFT9701 instruction manual Re-installing the circuit board compartment cover

Getting Started continued

2.3.3Re-installing the circuit board compartment cover

To re-install the cover of the circuit board compartment:

1.Screw the cover back onto the housing.

2.Hand-tighten the cover until it seats on the O-ring.

3.If the circuit board compartment has a lockout device, as shown in Figure 2-2, rotate the clamp into place and push it into the slot. Use a 4-mm (5/32-inch) Allen wrench to tighten the lockout screw to 5 inch-pounds (0,56 N-m) of torque.

10 Model IFT9701 Transmitter Instruction Manual