KitchenAid 2316565B manual Move the Refrigerator into House, Install Anti-Tip Boards

Page 19

Move the Refrigerator into House

WARNING

Tip Over Hazard

Refrigerator is top heavy and tips easily when not completely installed.

Keep doors taped closed until refrigerator is completely installed.

Use two or more people to move and install refrigerator.

Failure to do so can result in death or serious injury.

1.Place an appliance dolly under the left side of the refrigerator as shown. Be sure to protect the side trims and handles. Place the corner posts from the packing materials over the trims and handles as appropriate. Slowly tighten the strap.

NOTE: Pass the dolly strap under the handles for the Architect® Series.

2.Place pieces of the shipping carton on the floor when rolling the dolly and refrigerator into the house. Move the refrigerator close to the built-in opening.

3.Place top of cardboard carton or plywood under refrigerator.

4.Stand the refrigerator up. First, place the left bottom edge of the refrigerator on the floor, stand the refrigerator upright and then lower the right-hand side of the refrigerator to the floor.

5.Do not remove protective film or cover.

6.Reassemble the trim and top grille after the dolly has been removed from the refrigerator.

Install Anti-Tip Boards

IMPORTANT:

■To avoid tipping during use, the solid soffit must be within 1" (2.5 cm) maximum above the refrigerator. If the solid soffit is higher than 1" (2.5 cm) or one is not available, then the refrigerator must be braced.

■It is recommended that board(s) be installed before the refrigerator is installed.

■Board(s) must be long enough to fully cover the width of the compressor cover.

■Locate the board(s) so the bottom surface(s) of the board(s) is(are) 84" (213 cm) from the floor.

■During installation, raise the refrigerator up so there is ¹⁄₄" (6.35 mm) maximum between the top of the refrigerator and the bottom of the anti-tip board(s). Do not crush the compressor cover when raising the rear leveling legs.

To Install Anti-tip Boards

1.Mark the stud locations on rear wall 80" to 90" (203 cm to 229 cm) above floor.

2.Securely attach one or two 2" x 4" x 32" (5 cm x 10 cm x 81 cm) boards to wall studs behind refrigerator. Use six #8 x 3" (7.6 cm) (or longer) wood screws. The wood screws must be screwed into the studs at least 1½" (3.8 cm). The board(s) must overlap the compressor cover.

A B

C

2" (5 cm)

D

A. Center board ¹⁄₄" (6.35 mm) max. above refrigerator

B. Two 2" x 4" x 32" (5 cm x 10 cm x 81 cm) boards

C. Attach to studs with six #8 x 3" (7.6 cm) screws

D. Compressor cover

Connectthe Water Supply

Read all directions before you begin.

IMPORTANT: If you turn the refrigerator on before the water line is connected, turn the ice maker OFF.

Style 1 - Shutoff Valve Connection

NOTE: If your water line connection does not look like Style 1, see “Style 2 - Copper Line Connection.”

1.Unplug refrigerator or disconnect power supply.

IMPORTANT: Before attaching the tubing to shutoff valve, flush the main water supply line to remove particles and air in the water line. Allow enough flow so that water becomes clear. Flushing the water line may help avoid filters and/or water valves from becoming clogged.

19

Page 18 Page 20
Image 19
Page 18 Page 20
Contents Side by Side BUILT-IN Refrigerator Table of Contents/Índice/Table des matièresÍndice Table of ContentsTable DES Matières Your safety and the safety of others are very important Refrigerator SafetyClassic Series ModelsSide by Side Non-Dispensing Refrigerators Architect SeriesComplete Series Side by Side Dispensing RefrigeratorsLocation Requirements Installation RequirementsOpening Dimensions Toolsand PartsRecommended Grounding Method Electrical RequirementsModel Width a as shown above Reverse Osmosis Water Supply Water Supply RequirementsTipping Radius Water PressureModel Width a Trim edge to trim edge ProductDimensionsSide View Front View Top View48 121.9 cm Models Door SwingDimensions36 91.4 cm Models 42 106.7 cm ModelsOverlay SeriesDoor Panel & CabinetryClearance Overlay PanelOverlayPanel Decorative Overlay Panels Model OverlaySeries Custom Panelsand Handle KitsBacker Panels Model Classic SeriesFactory Panelsand Kits Door Panels for Non-dispenser Models ClassicSeries Custom PanelsDoor Panels for Dispenser Models Top Grille PanelRefrigerator Refrigerator and Side Trim DimensionsClassic, Architect and Complete Series Custom Side Panels Door Panels Routing RequirementsOverlaySeries Custom Side Panels Refrigerator Inset Installation DimensionsFlush Installation Dimensions Recessed Inset Installation DimensionsMeasure the distance from point a as shown to back wall Installation InstructionsUnpack the Refrigerator Reduce TippingRadiusConnectthe Water Supply Install Anti-Tip BoardsTo Install Anti-tip Boards Move the Refrigerator into HouseConnecting to Refrigerator Style 2 Copper Line Connection Connecting to Water LineMoveRefrigerator toFinal Location Plug in RefrigeratorLevel and Align Refrigerator Check refrigerator level and adjustment. Adjust if needed Install ClassicSeries Custom PanelsDoor Panels Door Panel Installation Install OverlaySeries Custom PanelsDoor-to-Door or Door-to-Refrigerator Trim Adjustment Adjust DoorsDoor Height Adjustment Door Swing AdjustmentInstall Base Grille Install Side PanelSnap the skirt onto the base grille Water System Preparation Complete InstallationStyle 1 Non-Dispenser Models Style 2 Dispenser Models Page Su seguridad y la seguridad de los demás es muy importante Seguridad DEL RefrigeradorSerie Classic ModelosRefrigeradores de dos puertas sin despachador Serie ArchitectSerie Completa Refrigeradores de dos puertas con despachadorMedidas de la abertura Requisitos DE InstalaciónPiezas y herramientas Requisitosde ubicaciónMétodo de conexión a tierra recomendado RequisitoseléctricosModelo Ancho a Como se muestra anteriormente Suministro de agua de ósmosis inversa Requisitosdel suministro de aguaArco devuelco Presión del aguaModelo Ancho a Medidas delproductoVista lateral Vista frontal Vista superiorModelos de 48 121,9 cm Medidas de oscilación de las puertasModelos de 36 91,4 cm Modelos de 42 106,7 cmPuerta Panel Paneles de soporte Modelo Paneles decorativos recubiertos ModeloPaneles y juegos de fábrica delaserie Classic Paneles de puerta para modelos sin despachador Panelesa la medida para la serie ClassicPaneles de puerta para modelos con despachador Panel de la rejilla superiorAgarradera extendida Vista superior Requisitos de contorneado de los paneles de la puertaMedidas del refrigerador y del adorno lateral RefrigeradorMedidas para la instalación al ras Paneles laterales a la medida para la Serie OverlayAdornos laterales Medidas para la instalación empotradaModelo Arco de vuelco reducido Instrucciones DE InstalaciónDesempaque el refrigerador Cómoreducirelarco de vuelcoCómo instalar los tableros antivuelco Cómo instalarlos tablerosantivuelcoLea todas las instrucciones antes de comenzar Conexión del suministro de aguaEstilo 1 Conexión de la válvula de cierre Conexión al refrigeradorCómo mover el refrigerador a su ubicación Final Cómo enchufar elrefrigeradorNivelación yalineamientodel refrigerador Paneles de la puerta Cómo instalar los paneles a la medida para la Serie ClassicInstalación del panel de la puerta Modelos Classic y Architect Ajuste laspuertasCómo ajustar la altura de la puerta Cómo ajustar la oscilación de las puertasCómo instalar la rejilla de la base Cómoinstalar el panellateralPreparación del sistema de agua Cómoterminarla instalaciónVotre sécurité et celle des autres est très importante Sécurité DU RéfrigérateurSérie Classic ModèlesRéfrigérateurs côte à côte sans distributeur Série ArchitectSérie Complète Réfrigérateurs côte à côte avec distributeurOutillage etpièces Exigences D’INSTALLATIONExigences d’emplacement Dimensions de l’ouvertureSpécificationsélectriques Méthode recommandée de mise à la terreModèle Largeur a tel quillustré ci-dessus Alimentation en eau par osmose inverse Spécifications de l’alimentation en eauRayon debasculement Pression de leauModèle Largeur a Dimensions du produitVue latérale Vue avant Vue de dessusModèles de 48 121,9 cm Dimensionspour le pivotement desportesModèles de 36 91,4 cm Modèles de 42 106,7 cmPorte Panneau Charnière Porte Panneau décoratif Overlay Modèle Panneaux personnalisés et poignéesde la série OverlayPanneau d’appui Modèle Ensemblesde panneaux dorigine de la série Classic Panneaux de porte pour modèles sans distributeur Panneaux personnalisés de la Série ClassicPanneaux de porte pour modèles avec distributeur Panneau de la grille supérieurePoignée de porte prolongée Vue supérieure Dimensions du réfrigérateur et des garnitures latéralesExigences dusinage des panneaux de porte RéfrigérateurPanneaux latéraux personnalisés de la Série Overlay Dimensions pour un panneau inséréDimensions pour un panneau en affleurement Dimensions pour un panneau inséré en retraitModèle Rayon de basculement réduit Instructions D’INSTALLATIONDéballage du réfrigérateur Réduction du rayon de basculementInstallation des planches antibasculement Installation de planchesantibasculementFaire entrerle réfrigérateur dans le domicile Ouvrir le robinet darrêt Raccordementà la canalisation deauStyle 1 Raccordement sur robinet darrêt Raccordement au réfrigérateurBrancher le réfrigérateur Déplacementdu réfrigérateur à Lemplacement finalRéglage de laplomb etalignement du Réfrigérateur Panneaux de porte Installation despanneaux personnalisés De la Série ClassicInstallation des panneaux de porte Installation despanneaux personnalisés De la Série OverlayModèles Classic et Architect Ajustement desportesAjustement de la hauteur des portes Ajustement du pivotement des portesInstallation de la grille de la base Installation du panneau latéralStyle 1 Modèles sans distributeur Acheverl’installationPréparation du système d’eau Veuillez lire avant d’utiliser le système d’eauAll rights reserved 2316565B

2316565B specifications

The KitchenAid 2316565B is a versatile and powerful kitchen appliance that enhances the cooking experience for home chefs and baking enthusiasts alike. Known for its durable construction and innovative features, this stand mixer is a must-have tool in any modern kitchen.

One of the standout features of the KitchenAid 2316565B is its robust 325-watt motor. This powerful motor ensures that the mixer can handle a variety of tasks, from kneading dense bread dough to whipping egg whites into fluffy peaks. The mixer operates with a reliable planetary mixing action, which means that the bowl and the beater rotate in opposite directions, ensuring that all ingredients are mixed thoroughly and evenly.

The KitchenAid 2316565B boasts a large capacity bowl that can hold up to 5 quarts. This generous size allows for mixing large batches of dough or batter, making it ideal for large families or entertaining guests. The stainless steel bowl is not only sturdy but also comes with a comfortable handle and is dishwasher safe, making cleanup a breeze.

Another impressive feature of this stand mixer is its 10-speed screw control. This allows users to easily adjust the mixing speed for various tasks, from slow stirring to fast whipping. The precision of the speed settings ensures that users can achieve the perfect consistency for every recipe.

KitchenAid has also designed the 2316565B with a tilt-head mechanism. This thoughtful design allows for easy access to the mixing bowl and makes it simple to add ingredients while the mixer is in operation. The mixer comes with a range of accessories, including a flat beater, a dough hook, and a wire whip, catering to different mixing needs and recipes.

In addition to its functionality, the KitchenAid 2316565B is available in a variety of colors, allowing users to choose one that fits their kitchen aesthetic. The mixer's classic design and robust performance make it not only a practical kitchen tool but also a stylish addition to any countertop.

Overall, the KitchenAid 2316565B stand mixer is a reliable, efficient, and aesthetically pleasing appliance that provides an enjoyable cooking experience. Whether you're a beginner in the kitchen or a seasoned chef, this stand mixer is designed to meet all your mixing, kneading, and whipping needs, making it a valuable addition to any home.
Top Page Image Contents