Frymaster KSCF18G manual Remains after closing drain

KSCF18G COOL ZONE SERIES GAS FRYERS

CHAPTER 7: TROUBLESHOOTING

7.2 Fryer Troubleshooting (cont.)

		1.	Computer was turned OFF while draining
			frypot.
		2.	Close drain valve. Turn computer OFF
			and ON again. Computer display will
			read ON.
		3.	Open drain valve. Computer display
			will read DRAIN OPEN. After 30
			seconds the computer display will read
			FILL.
7.2.4	DRAIN OPEN message	4.	Close drain valve.
	remains after closing drain	5.	Fill frypot with shortening. Press
	valve.
			EXIT/COOL FILTER when ready to
			cook.
		6.	If the computer message DRAIN
			OPEN remains after Steps 1-4, contact
			an authorized service agent. Possible
			malfunctions are:
			a.	Drain microswitch may be faulty.
			b.	Drain circuit is suspect.
			c.	Computer is suspect.
		1.	The motor thermal overload or the 10 amp
			circuit breaker has tripped. If the thermal
			overload trips, wait approximately 45
			minutes. Press the button on the end of the
			filter motor. If the 10 amp circuit breaker
			trips, reset it (located under the control
	Pump motor won’t start or		panel of the right-had fryer).
7.2.5
	stops during filtering.	2.	If you have to do this repeatedly, stop
			resetting the overload or circuit breaker
			and contact an authorized service agent.
		NOTE: This is usually caused by allowing
		large particles of food to enter the pump
		during filtering. Ensure that the filter paper
		and crumb screen are properly in place.
		7-4