AEG 64800 manual Adjusting the height of the upper basket

Page 21

Adjusting the height of the upper basket

If washing very large plates (over 27 cm and up to 31 cm in diameter) you can load them in the lower basket after moving the upper basket to the higher position.

To move to the higher position proceed as follows:

1.Move the front runner stops (A) of the upper basket outwards and slide the basket out.

2.Refit the basket in the higher position and replace

the stops (A) in their original position.

A

RC01

Attention!

When the top basket is in the higher position it will only take plates up to 20 cm in diameter and you will not be able to use the raised cup racks.

After loading your machine always close the door, as an open door can be a hazard.

21

Image 21
Contents Ökofavorit Please read these user instructions carefully Dear customerContents Using your dishwasher for its intended purpose Safety instructionsBefore using your dishwasher for the first time Child safetyYour dishwasher in day-to-day use Disposing of packaging and old machine Disable the door lock so that the door no longer closesDisposing of the packaging Disposing of your old machineEconomical and ecological dishwashing Inside of the appliance Description of the applianceIndicator lights Programme phase indicator lightsDoor handle Digital display Small load pushbutton SaltDelay start pushbutton SO280 Setting the water hardness range Before using your dishwasher for the first timeTo set a different level, proceed as follows To fill Filling with special saltRinse-aid Filling up the rinse-aidEnsure that the lid is closed after every refill Adjusting the dose Loading cutlery and dishes Lower basket Removable knife basketTo lower the prongs Cutlery basket Upper basket Adjusting the height of the upper basket Use of detergent If using detergent in tablets proceed as followsBIO programmes and compact powders Washing programmes Cycle description Approximate valuesOperating instructions Setting of the programme may occur 8a. Set and start the programme without delay start8b. Set and start the programme with delay start At the end of the washing programme To cancel a programmePage Maintenance and cleaning Internal and external cleaningCleaning the filters Together What to do, when Flashing fault code appearsDishes are not clean Problems occur during use of the dishwasherWash results are not satisfactory Visible lime deposits or white film on the dishesCustomer service Hints for test centres Technical specifications Technical dataAdjusting the worktop Installation and connection instructionsFitting under a counter LevellingConnecting the water supply Water outlet connection Extension hoses Electrical connection Water protection systemCopyright by AEG 152985 56/1