AEG 64800 manual Operating instructions

Page 26

26

Operating instructions

1.Check the filters

Ensure they are clean and properly positioned (see "Maintenance and cleaning").

2.Press the On/Off pushbutton

The On/Off indicator light will illuminate and in three horizontal lines (- - - ) will appear in the display.

3.Check that there is rinse aid and salt

The corresponding indicator lights will illuminate if refilling is necessary.

4.Load the dishes

Remove any scraps of food.

Pull the lower basket out and arrange the saucepans, plates and cutlery in it.

Pull the upper basket out and arrange the plates, saucers, glasses and cups etc. in it.

Slide the baskets back into the machine.

5.Ensure that the spray arms can rotate freely.

6.Add the detergent

As all detergents are not the same, you should also consult the instructions on the packet.

Close the detergent dispenser lid.

7.Open the water tap

Image 26

Contents Ökofavorit Dear customer Please read these user instructions carefullyContents Before using your dishwasher for the first time Safety instructionsUsing your dishwasher for its intended purpose Child safetyYour dishwasher in day-to-day use Disposing of the packaging Disable the door lock so that the door no longer closesDisposing of packaging and old machine Disposing of your old machineEconomical and ecological dishwashing Description of the appliance Inside of the applianceDoor handle Digital display Small load pushbutton Programme phase indicator lightsIndicator lights SaltDelay start pushbutton SO280 Before using your dishwasher for the first time Setting the water hardness rangeTo set a different level, proceed as follows Filling with special salt To fillEnsure that the lid is closed after every refill Rinse-aidFilling up the rinse-aid Adjusting the dose Loading cutlery and dishes To lower the prongs Lower basketRemovable knife basket Cutlery basket Upper basket Adjusting the height of the upper basket If using detergent in tablets proceed as follows Use of detergentBIO programmes and compact powders Washing programmes Approximate values Cycle descriptionOperating instructions 8a. Set and start the programme without delay start Setting of the programme may occur8b. Set and start the programme with delay start To cancel a programme At the end of the washing programmePage Cleaning the filters Maintenance and cleaningInternal and external cleaning Together Flashing fault code appears What to do, whenWash results are not satisfactory Problems occur during use of the dishwasherDishes are not clean Visible lime deposits or white film on the dishesCustomer service Hints for test centres Technical data Technical specificationsFitting under a counter Installation and connection instructionsAdjusting the worktop LevellingConnecting the water supply Water outlet connection Extension hoses Water protection system Electrical connectionCopyright by AEG 152985 56/1