AEG 64800 manual What to do, when, Flashing fault code appears

Page 33

What to do, when...

Try to rectify minor faults on the dishwasher with the aid of the instructions given here.

...a flashing fault code appears

an audible signal informs you that an alarm has been activated, in the display appears one of the following flashing alarms: AL1 - AL2 - AL3 - AL4 - AL5 - AL6 - AL7 and the indicator light of the phase under way is flashing. They are indicative of a fault in the dishwasher that you can probably rectify yourself.

-press the On/Off pushbutton to switch the dishwasher off

-open the door and carry out the following suggested corrective actions.

Fault code

"Open door" indicator light flashes

"Water tap" indicator light

Possible cause		Remedy

The door has not been		Close the door.
properly closed.


The water tap is closed.		Open the water tap.

The mains water supply has
been cut off.

flashes and/or alarm AL5

Alarm AL6

Alarm AL4

Alarms AL1 - AL2 - AL3 - AL7 - AL8

The inlet hose may be squashed or bent.

The inlet hose may be blocked.

The drain hose may be squashed or bent. The drain hose extension is not correct.

The sink may be blocked.

Protection against flooding is active.

General

Reposition correctly the hose.

Switch off the water supply and clean the filter.

Reposition correctly the drain hose. Follow the instructions for connecting to the waste.

Clear any blockages.

Close the water tap and contact the Service Centre.

Open the door, switch off the dishwasher, switch back on and start a wash programme. If the fault code reappears contact the Service Centre.

Once checked the possible causes listed above, switch on the dishwasher and start a wash programme, if the fault code reappears contact the Service Centre.

33

Image 33

Contents Ökofavorit Please read these user instructions carefully Dear customerContents Using your dishwasher for its intended purpose Safety instructionsBefore using your dishwasher for the first time Child safetyYour dishwasher in day-to-day use Disposing of packaging and old machine Disable the door lock so that the door no longer closesDisposing of the packaging Disposing of your old machineEconomical and ecological dishwashing Inside of the appliance Description of the applianceIndicator lights Programme phase indicator lightsDoor handle Digital display Small load pushbutton SaltDelay start pushbutton SO280 Setting the water hardness range Before using your dishwasher for the first timeTo set a different level, proceed as follows To fill Filling with special saltRinse-aid Filling up the rinse-aidEnsure that the lid is closed after every refill Adjusting the dose Loading cutlery and dishes Lower basket Removable knife basketTo lower the prongs Cutlery basket Upper basket Adjusting the height of the upper basket Use of detergent If using detergent in tablets proceed as followsBIO programmes and compact powders Washing programmes Cycle description Approximate valuesOperating instructions Setting of the programme may occur 8a. Set and start the programme without delay start8b. Set and start the programme with delay start At the end of the washing programme To cancel a programmePage Maintenance and cleaning Internal and external cleaningCleaning the filters Together What to do, when Flashing fault code appearsDishes are not clean Problems occur during use of the dishwasherWash results are not satisfactory Visible lime deposits or white film on the dishesCustomer service Hints for test centres Technical specifications Technical dataAdjusting the worktop Installation and connection instructionsFitting under a counter LevellingConnecting the water supply Water outlet connection Extension hoses Electrical connection Water protection systemCopyright by AEG 152985 56/1