AEG 64800 manual Problems occur during use of the dishwasher, Wash results are not satisfactory

Page 34

...problems occur during use of the dishwasher

Malfunction

The programme does not start

The machine is noisy

The door is difficult to close

Possible cause

The plug is not properly inserted in the power socket.

There is no current at the socket.

Dishes are rattling against each other.

The spray arms are knocking against the dishes.

The dishwasher is not level, or not properly built-in.

Remedy

Insert the plug.

Load correctly crockery, cutlery, pots and pans. Refer to "Loading cutlery and dishes"

Refer to "Installation" instructions.

34

...the wash results are not satisfactory

Visible lime deposits or white film on the dishes

●Check that the right level of the water softener is setted.

●Check that there is salt.

The dishes are not quite dry

●The rinse aid has run out or too little is being used.

The dishes are not clean

●The baskets are too full.

●The dishes have not been arranged properly.

●The spray arms do not rotate because incorrect loading of the baskets.

●The filters are clogged.

●The filters are not in position.

●Not enough detergent has been used or it is unsuitable.

●The detergent is old or has gone hard.

●The salt container cap is not properly closed.

●The washing programme is too gentle.

Image 34

Contents Ökofavorit Dear customer Please read these user instructions carefullyContents Before using your dishwasher for the first time Safety instructionsUsing your dishwasher for its intended purpose Child safetyYour dishwasher in day-to-day use Disposing of the packaging Disable the door lock so that the door no longer closesDisposing of packaging and old machine Disposing of your old machineEconomical and ecological dishwashing Description of the appliance Inside of the applianceDoor handle Digital display Small load pushbutton Programme phase indicator lightsIndicator lights SaltDelay start pushbutton SO280 Before using your dishwasher for the first time Setting the water hardness rangeTo set a different level, proceed as follows Filling with special salt To fillFilling up the rinse-aid Rinse-aidEnsure that the lid is closed after every refill Adjusting the dose Loading cutlery and dishes Removable knife basket Lower basketTo lower the prongs Cutlery basket Upper basket Adjusting the height of the upper basket If using detergent in tablets proceed as follows Use of detergentBIO programmes and compact powders Washing programmes Approximate values Cycle descriptionOperating instructions 8a. Set and start the programme without delay start Setting of the programme may occur8b. Set and start the programme with delay start To cancel a programme At the end of the washing programmePage Internal and external cleaning Maintenance and cleaningCleaning the filters Together Flashing fault code appears What to do, whenWash results are not satisfactory Problems occur during use of the dishwasherDishes are not clean Visible lime deposits or white film on the dishesCustomer service Hints for test centres Technical data Technical specificationsFitting under a counter Installation and connection instructionsAdjusting the worktop LevellingConnecting the water supply Water outlet connection Extension hoses Water protection system Electrical connectionCopyright by AEG 152985 56/1