AEG 64800 manual Connecting the water supply

Page 39

Connecting the water supply

●Your dishwasher can be connected to either a cold or hot water supply of max. 60°C.

●Never connect your dishwasher to open hot water appliances and continuous flow heaters!

Nevertheless we advise you a cold water supply. A hot water supply is not always efficient with very soiled crockery as it shortens the washing programmes.

Avoid bends or kinks in the hose which could prevent or slow down the water supply.

If the machine is connected to new pipes or pipes which have not been used for a long time, you should run the water for a few minutes before connecting the inlet hose. This will prevent deposits of sand or rust clogging the inlet hose.

The water pressure must be within the limits given in the technical specifications.

Your dishwasher has been built in accordance with the valid regulations governing water-consuming appliances and is equipped with safety devices which prevent used water from flowing back into the drinking water mains.

39

Image 39

Contents Ökofavorit Please read these user instructions carefully Dear customerContents Child safety Safety instructionsUsing your dishwasher for its intended purpose Before using your dishwasher for the first timeYour dishwasher in day-to-day use Disposing of your old machine Disable the door lock so that the door no longer closesDisposing of packaging and old machine Disposing of the packagingEconomical and ecological dishwashing Inside of the appliance Description of the applianceSalt Programme phase indicator lightsIndicator lights Door handle Digital display Small load pushbuttonDelay start pushbutton SO280 Setting the water hardness range Before using your dishwasher for the first timeTo set a different level, proceed as follows To fill Filling with special saltRinse-aid Filling up the rinse-aidEnsure that the lid is closed after every refill Adjusting the dose Loading cutlery and dishes Lower basket Removable knife basketTo lower the prongs Cutlery basket Upper basket Adjusting the height of the upper basket Use of detergent If using detergent in tablets proceed as followsBIO programmes and compact powders Washing programmes Cycle description Approximate valuesOperating instructions Setting of the programme may occur 8a. Set and start the programme without delay start8b. Set and start the programme with delay start At the end of the washing programme To cancel a programmePage Maintenance and cleaning Internal and external cleaningCleaning the filters Together What to do, when Flashing fault code appearsVisible lime deposits or white film on the dishes Problems occur during use of the dishwasherDishes are not clean Wash results are not satisfactoryCustomer service Hints for test centres Technical specifications Technical dataLevelling Installation and connection instructionsAdjusting the worktop Fitting under a counterConnecting the water supply Water outlet connection Extension hoses Electrical connection Water protection systemCopyright by AEG 152985 56/1