AEG 64800 manual Water outlet connection

Page 40

40

Water outlet connection

The end of the drain hose can be connected as follows:

1.To the sink outlet siphon, securing it if necessary with a clip.

2.Hooked over the edge of the sink using the special curved plastic guide provided.

3.To a wall outlet provided with vent-hole, minimum internal diameter 4 cm.

			1	2	3
	21				4cm
Ø	21		18		min
Ø					min
		Ø
		Ø
				max 100 cm	min 30 cm max 100 cm
CS09

The waste connection must be at a height of between 30 cm (minimum) and 100 cm (maximum) from the floor.

It makes no difference which way the drain hose faces, either to the right or left of the dishwasher.

Avoid bending or kinking the hose as this could prevent or slow down the discharge of water.

Image 40

Contents Ökofavorit Dear customer Please read these user instructions carefullyContents Safety instructions Using your dishwasher for its intended purposeBefore using your dishwasher for the first time Child safetyYour dishwasher in day-to-day use Disable the door lock so that the door no longer closes Disposing of packaging and old machineDisposing of the packaging Disposing of your old machineEconomical and ecological dishwashing Description of the appliance Inside of the applianceProgramme phase indicator lights Indicator lightsDoor handle Digital display Small load pushbutton SaltDelay start pushbutton SO280 Before using your dishwasher for the first time Setting the water hardness rangeTo set a different level, proceed as follows Filling with special salt To fillFilling up the rinse-aid Rinse-aidEnsure that the lid is closed after every refill Adjusting the dose Loading cutlery and dishes Removable knife basket Lower basketTo lower the prongs Cutlery basket Upper basket Adjusting the height of the upper basket If using detergent in tablets proceed as follows Use of detergentBIO programmes and compact powders Washing programmes Approximate values Cycle descriptionOperating instructions 8a. Set and start the programme without delay start Setting of the programme may occur8b. Set and start the programme with delay start To cancel a programme At the end of the washing programmePage Internal and external cleaning Maintenance and cleaningCleaning the filters Together Flashing fault code appears What to do, whenProblems occur during use of the dishwasher Dishes are not cleanWash results are not satisfactory Visible lime deposits or white film on the dishesCustomer service Hints for test centres Technical data Technical specificationsInstallation and connection instructions Adjusting the worktopFitting under a counter LevellingConnecting the water supply Water outlet connection Extension hoses Water protection system Electrical connectionCopyright by AEG 152985 56/1