AEG 64800 manual Installation and connection instructions, Adjusting the worktop, Levelling

Page 38

Installation and connection instructions

Adjusting the worktop

You can move the worktop forward or backward by 25 mm in order to align the machine with other kitchen units.

Simply unscrew the two front retaining screws, move the top to the required position and then retighten the screws.

IN02

Fitting under a counter

(kitchen worktop or sink)

By removing the machine’s worktop, you can install it under a close fitting sink unit or a pre-existing top, providing the dimensions of the recess correspond to those shown in the picture.

Proceed as follows:

-Remove the machine’s worktop by unscrewing the two front retaining screws, pull from the front and slide out the rear slots, lifting the worktop.

570-

600

820

450

IN04

38

Insert the machine after adjusting height and levelling with the adjustable feet. When inserting the machine, ensure that the water inlet and drain hoses are not kinked or squashed.

Levelling

Good levelling is essential for correct closure and sealing of the door. When the appliance is correctly levelled, the door will not catch on the levelling spacers, either side of the cabinet.

If the door does not close correctly, loosen or tighten the adjustable feet until the machine is perfectly level.

Image 38

Contents Ökofavorit Dear customer Please read these user instructions carefullyContents Before using your dishwasher for the first time Safety instructionsUsing your dishwasher for its intended purpose Child safetyYour dishwasher in day-to-day use Disposing of the packaging Disable the door lock so that the door no longer closesDisposing of packaging and old machine Disposing of your old machineEconomical and ecological dishwashing Description of the appliance Inside of the applianceDoor handle Digital display Small load pushbutton Programme phase indicator lightsIndicator lights SaltDelay start pushbutton SO280 Before using your dishwasher for the first time Setting the water hardness rangeTo set a different level, proceed as follows Filling with special salt To fillEnsure that the lid is closed after every refill Rinse-aidFilling up the rinse-aid Adjusting the dose Loading cutlery and dishes To lower the prongs Lower basketRemovable knife basket Cutlery basket Upper basket Adjusting the height of the upper basket If using detergent in tablets proceed as follows Use of detergentBIO programmes and compact powders Washing programmes Approximate values Cycle descriptionOperating instructions 8a. Set and start the programme without delay start Setting of the programme may occur8b. Set and start the programme with delay start To cancel a programme At the end of the washing programmePage Cleaning the filters Maintenance and cleaningInternal and external cleaning Together Flashing fault code appears What to do, whenWash results are not satisfactory Problems occur during use of the dishwasherDishes are not clean Visible lime deposits or white film on the dishesCustomer service Hints for test centres Technical data Technical specificationsFitting under a counter Installation and connection instructionsAdjusting the worktop LevellingConnecting the water supply Water outlet connection Extension hoses Water protection system Electrical connectionCopyright by AEG 152985 56/1