AEG 64800 manual Technical data, Technical specifications

Page 37

Technical data

Technical specifications

Dimensions		Width	45 cm
		Height with worktop	85 cm
		Height without worktop	82 cm
		Max depth	60 cm
		Max depth with open door	115,2 cm


Electrical connection			230 V - 50 Hz
Motor rating during wash			200	W
Power of heating element			2100	W
Overall power			2300	W


Water supply pressure		Minimum	50 kPa (0.5 bar)
		Maximum	800 kPa (8 bar)


Capacity			9 place settings

This appliance complies with the following E.E.C. Directives:

-73/23/CEE of 19/02/73 (Low Voltage Directive) and subsequent modifications;

-89/336/CEE of 03/05/89 (Electromagnetic Compatibility Directive) and subsequent modifications.

37

Image 37

Contents Ökofavorit Please read these user instructions carefully Dear customerContents Using your dishwasher for its intended purpose Safety instructionsBefore using your dishwasher for the first time Child safetyYour dishwasher in day-to-day use Disposing of packaging and old machine Disable the door lock so that the door no longer closesDisposing of the packaging Disposing of your old machineEconomical and ecological dishwashing Inside of the appliance Description of the applianceIndicator lights Programme phase indicator lightsDoor handle Digital display Small load pushbutton SaltDelay start pushbutton SO280 Setting the water hardness range Before using your dishwasher for the first timeTo set a different level, proceed as follows To fill Filling with special saltFilling up the rinse-aid Rinse-aidEnsure that the lid is closed after every refill Adjusting the dose Loading cutlery and dishes Removable knife basket Lower basketTo lower the prongs Cutlery basket Upper basket Adjusting the height of the upper basket Use of detergent If using detergent in tablets proceed as followsBIO programmes and compact powders Washing programmes Cycle description Approximate valuesOperating instructions Setting of the programme may occur 8a. Set and start the programme without delay start8b. Set and start the programme with delay start At the end of the washing programme To cancel a programmePage Internal and external cleaning Maintenance and cleaningCleaning the filters Together What to do, when Flashing fault code appearsDishes are not clean Problems occur during use of the dishwasherWash results are not satisfactory Visible lime deposits or white film on the dishesCustomer service Hints for test centres Technical specifications Technical dataAdjusting the worktop Installation and connection instructionsFitting under a counter LevellingConnecting the water supply Water outlet connection Extension hoses Electrical connection Water protection systemCopyright by AEG 152985 56/1