Panasonic CF-35 Computer Diagnosis, List of Error Codes, Using the Self-diagnosis Program

Computer Diagnosis

List of Error Codes

If a problem occurs with your hardware, [POST Start up Error(s)] is displayed along with the error code(s), follow the on-screen instructions.

	Setup:	Setup Utility (	page 36) is started. Run [Load Default Settings (PnP)].
		Next the Setup Utility must be run again to input the appropriate operating environ-
		ment settings.
	Exit:	Ignore the error message(s), and restart the computer.
Code				Description
062	Boot failure--default configuration used			Default configuration in use
101	System Board Failure			Interrupt controller failure
102	System Board Failure			Timer 2 test failure
106	System Board Failure			Diskette controller failure
114	Adapter ROM Error			Adapter ROM checksum error
151	System Board Failure			Real-time clock failure
161	Bad CMOS Battery			Dead battery
162	Configuration Change Has Occurred			Configuration error
162	Configuration Error			CMOS checksum error
163	Date and Time Incorrect			Real-time clock is not updating
173	Configuration Change Has Occurred			ROM configuration has changed
201	Memory Size Error			Memory size/data error
301	Keyboard Error			Keyboard failure
303	Keyboard Error			Keyboard controller failure
604	Diskette Drive Error			Diskette drive 0 failure
605	Diskette Drive Error			Diskette unlocked problem
1780	Hard Disk Error			Fixed disk 0 failure
1800	PCI Error			No more IRQs available
1801	PCI Error			No more room for optional ROM
1802	PCI Error			No more I/O space available
1803	PCI Error			No more memory (above 1 MB) available
1804	PCI Error			No more memory (below 1 MB) available
1805	PCI Error			Checksum error or 0 size optional ROM
1962	IPL Error			An operating system could not be found
8601	Pointing Device Error			Pointing device failure
I9990301	IPL Error			Hard disk failure
I9990305	IPL Error			An operating system could not be found

Using the Self-diagnosis Program

Follow the procedure below to check whether each part of your computer is operating properly.

1 To run the program, insert the Firstaid FD you created into the floppy disk drive, then turn your computer on

2 When the display below is shown, select [1. Boot]

1.Boot

2.Restore HDD to factory default (For beginners)

3.Restore HDD to factory default (For advanced users)

3 At the MS-DOS prompt (A:\WINDOWS\COMMAND>), input the following:

diag35

Follow the messages on the screen.

28