SET Preinfusion, Batches DONE? | Bunn SNG0033000 guide

PROGRAMMING THE BREWER (cont.)

SET PREINFUSION:

This function sets the brewer to turn the sprayhead flow on for a preset time (1st ON TIME) followed by a preset spray pause (OFF TIMES) and then turn the spray on continuously until the brew volume is completed.

This is a special case of pulse brew. It is not pos- sible to set a batch size to have both pulse brew and preinfusion. One or the other (or neither) must be chosen. However, it is possible to set one batch size to pulse brew and the other two to preinfusion or vice versa.

NOTE: The procedure to enter the PULSE BREW function must be performed prior to following the steps listed below.

1.Press and release YES. The display should now read EASY PULSE SETUP.

2.Press and release NO. The display will read ENTER

TIMES?

3.Press YES to proceed. The display should now read 1st ON TIME X:XX.

4.Using (-)and (+) set the amount of time the flow of water into the funnel will be on.

5.When finished, press DONE. The display will now read OFF TIMES: X:XX.

6.Using (-)and (+) set the amount of time the flow of water into the funnel will be off.

7.When finished, press DONE. The display will now read LAST ON: PreI

8.If the display shows a time use (-)and (+) to set it to read PreI. (PreI is an abreviation for preinfu- sion)

9.When finished, press DONE. The display will show the two settings and PreI just entered for that batch size. After a 5 second delay, the display will read

3 BATCHES DONE?

10.If other batch sizes need to be modified, press

NO.

12.Press a different batch size pad and repeat steps 3 through 7. Repeat until all the desired batch sizes are set for the left side.

13.When finished press YES in 3 BATCHES DONE?. The display will then read DRIP TIME.

14.Press and release the ON/OFF switch (either on DUAL brewers) located on the front switch panel to exit the SET PULSE BREW function and return to the MAIN SCREEN.

NOTE: Pressing the upper right hidden switch before reaching the final setting screen exits the setup and retains the old values.

SET PULSE BREW?
NO	YES
EASY PULSE SETUP
NO	YES	EXIT TO
		EXIT TO
		NEXT FUNCTION
		SCREEN
ENTER TIMES?
NO	YES

1st ON TIME X:XX (-) DONE (+)

OFF TIMES: X:XX (-) DONE (+)

LAST ON: Prel (-) DONE (+)

1st OFF LAST XX.X XX.X Prel

5 SEC. DELAY

3 BATCHES DONE?

NO YES

EXIT TO

NEXT FUNCTION

SCREEN

Page 24	41341 080108