Enable Energysavr, NEW Recipe ? | Bunn SNG0033000 specification

PROGRAMMING THE BREWER (cont.)

ENABLE ENERGYSAVR

This function allows the operator to enable the ENERGY SAVINGS mode function and set the idle time. Once the set idle time has expired, the operator can choose to have the heaters either turn off, or reduce the tank holding temp to 140° F (60° C).

Procedure to enable energy savings mode: Range: 0.5 to 24.0 hrs

If enabled, default setting is 140° F (60° C) tank tem- perature after 4.0 hrs. idle time.

1.	Press and hold the right hidden switch until the
	display reads SET LANGUAGE. Press the right
	hidden switch until the display reads Enabl Ener-
	gySavr. The YES or NO will be flashing to indicate
	the current selection.
2.	Press and release NO to disable this function, or:
3.	Press and release YES to enable this function (the
	heaters will either turn off or the tank will hold at

10.Once the idle time has expired, the display will read either ENERGY SAVER...NO TEMPERATURE or ENERGY SAVER...REDUCED TEMPERATURE, depending on the settings. This screen will alternate with PRESS ANY SWITCH TO RE-HEAT.

Enabl EnrgySavr

NO DONE YES

WITH YES FLASHING

PRESS DONE

	140° F).
4.	When finished, press and release DONE to save
	the new setting and advance to the next function
	screen.
5.	If NO was selected, the display should now read
	SET NEW RECIPE ?. To exit programming and
	return to the MAIN SCREEN, press and release
	the ON/OFF switch (either for DUAL Brewers).
6.	If YES was selected, the display should now read
	X.X HRS -> IDLE. This screen allows the opera-

WITH NO FLASHING

PRESS DONE TO

ADVANCE TO

ENABLEFRESHTIMER

X.X HRS -> IDLE (-) DONE (+)

AFTER IDLE TIME? OFF DONE 140°

tor to set the amount of time the brewer is not in

use before nap mode engages. Using (-)and (+),

adjust the idle time. When finished, press and

release DONE.

7. The display should now read AFTER IDLE TIME?

Once the set idle time has expired, the heaters can

either be shut off or held at a lower temperature

of 140° F.

8. To have the machine shut off after the set idle time,

press and release OFF and then DONE to save the

settings. The display should read MACHINE OFF

AFTER X.X HRS, and then SET NEW RECIPE ?.

9. To have the heaters hold at the lower 140° F tem-

perature, press and release 140° and then DONE

to save the settings. The display should read

MACHINE AT 140° AFTER X.X HRS, and then SET

NEW RECIPE ?.

MACHINE OFF	MACHINE AT 140°
AFTER X.X HRS	AFTER X.X HRS

SET NEW RECIPE ?

NO DONE YES

Page 12	41341 101911

PROGRAMMING THE BREWER (cont.)