Bunn SNG0033000 manual Spray OZ/M Single Brewers, Procedure to adjust the flow rate setting

PROGRAMMING THE BREWER (cont.)

SPRAY OZ/M (SINGLE BREWERS)

This function allows the operator to view or to enter the actual flow rate coming out of the sprayhead. This is NOT used to change the actual flow rate, but to tell the internal controller how fast the water is flowing. The unit of measure is ounces per minute. (Oz/M)

Procedure to adjust the flow rate setting:

1.Press and hold the upper right hidden switch until the display reads UNITS. Release the switch, then press and release switch until the display reads SPRAY OZ/M. The number represents what the brewer thinks is the flow rate of the sprayhead valve in ounces per minute.

2.If the actual flow rate of the sprayhead valve is known, but is different than the number on the display, use the (-)and (+) to enter the correct flow rate in ounces per minute.

3.When finished, press and release DONE. This saves the new setting and advances to the next function screen, BYPASS OZ/M. Another alternative is to press the ON/OFF switch located on the switch panel to exit SPRAY OZ/M function and return to the MAIN SCREEN.

SPRAY OZ/M (DUAL BREWERS)

This function allows the operator to view or to enter the actual flow rate coming out of the sprayhead. This is NOT used to change the actual flow rate, but to tell the internal controller how fast the water is flowing. The unit of measure is ounces per minute (Oz/M).

Procedure to adjust the flow rate setting:

1.Press and hold upper right hidden switch until the display reads UNITS. Release switch. Continue to press and release switch until the display reads, L SPRY OZ/M. The number represents what the brewer thinks is the flow rate of the sprayhead in ounces per minute.

2.If the actual flow rate of the sprayhead is known, but is different than the number on the display, use the (-)and (+) to enter the correct flow rate in ounces per minute.

3.When finished, press and release DONE. This saves the new setting and advances to R SPRY OZ/M. When finished setting the right side, press and release DONE to advance to next function screen, L BYPS OZ/M. Another alternative is to press and release either ON/OFF switch located on the front switch panel to exit R SPRY OZ/M function and return to the MAIN SCREEN.

SPRY OZ/M: XX.X	L SPRY OZ/M: XX.X
(-) DONE (+)
	(-) DONE (+)

BYPS OZ/M: XX.X	R SPRY OZ/M: XX.X
(-) DONE (+)
	(-) DONE (+)

L BYPS OZ/M: XX.X (-) DONE (+)

Page 29 41341 080108