Haier PRFS25 user manual Icemaker sensor arm so it rests

English

Problem	Cause	Solution
Automatic icemaker
The.	• The ice cube height sensor	• To make more ice cubes you
icemaker	arm has detected a full	may need to distribute your ice
has stopped	tray condition.	to the center drawer right side
making ice.		(or lower drawer) to increase
	• The water supply valve is	ice cube harvest volume.
		• Turn on the water supply valve.
	closed.
		• Adjust the setting in the freezer
	• The freezer section is not
		to colder setting and allow it to
	cold enough.
		balance within 24 hours.
	• The water source saddle	• Check the water supply.
		saddles valve for obstruction
	valve is somehow blocked.	and replace it if damaged.
The ice.	• The freezer drawer area is	• Set the freezer drawer to a
making	not cold enough.	colder setting.
capacity is		• Make sure the water pressure
low.
	• The water supply valve is	is between 25-121 psi and
		add water booster if too low.
	not high enough pressure
		• Make sure the water valve.
	or does not open all the
	way.	supply is open all the way.
		• Make sure the water filter is
	• The icemaker sensor arm	distributing enough water and
		is not clogged.
	is restricted or out of.
	position.	• Make sure the drawer gaskets
		are sealing and kept clean
		from dirt and debris.
The.	• The icemaker level sensor	• Check the movement of the.
icemaker	is stuck in the down.	icemaker sensor arm so it rests
runs.	position.	in the “up” position.
continuously.		• Make sure no frozen packs or
		objects are obstructing the.
		icemaker sensor arm.

33