Ice-O-Matic GEM0956R, GEM1256R, GEM0650R installation manual Low Condensing Temperature

Page 28

GEM0650/0956/1256 Remote

Operation: Refrigeration

Low Condensing Temperature

The refrigeration system under low condenser air temperatures is much the same as it is under higher temperatures, with the exception that the resulting low head pressures cause the head pressure control to close off the liquid line between the condenser and the receiver.

This forces more refrigerant into the condenser (with a small amount of discharge gas going into the receiver to maintain pressure until the head pressure is built back up to 180 PSIG). At that pressure the valve opens up the liquid line from the condenser to the receiver.

Refrigeration Schematic

Remote Condenser

Discharge

Liquid Line

Line

Detail of Head Pressure Control Valve

Liquid Line Valve

Thermostatic Expansion Valve

Head Pressure

Control Valve

Evaporator

Receiver

 

Compressor

 

 

 

 

Suction Line

 

 

 

 

 

 

 

 

 

 

 

Page 22

Image 28
Contents Pearl Ice Series By Ice-O-MaticPage Introduction Keep this manual for future referenceTable Of Contents Freight Claim Procedure Inspect PromptlyVisible Loss or Damage Concealed Loss or DamageWarranty Governing LAWFor the Installer GEM0650/0956R GEM1256R Ice Machine Specifications Bin ApplicationLocation Storage BinIce machine Water LimitationsERC Dimensions Inches GRC1001 GRC1061 GCR2061 Remote CondenserPearl Ice Number Line SetsCalculation Formula Remote Condenser LocationCalculation Example Roof Attachment Remote Condenser LocationPrecharged Line Set Routing Typical Installation Coupling Instructions Initial Connections Final ConnectionsWater Inlet For the PlumberDrains Ice Machine For the Electrician Completed Installation Final Check List There are no adjustments to make, so replace the panels Start UpPre-Start Inspection Start UpComponent Description Control Board GEM0650/0956/1256 Remote Electrical Sequence Operation Water WaterWater Level Water SystemRefrigeration Schematic Operation RefrigerationLow Condensing Temperature Pump Down Operation Performance Sanitizing and Cleaning Condenser Maintenance Brush in direction of finsBearing Maintenance Bearing MaintenanceBin Control Sensor Sensor MaintenanceWater Sensor Auger Maintenance AugerService Diagnosis Symptom Possible Cause Probable CorrectionSymptom Control System Diagnostics High pressure cut out checkWater Reservoir Water Reservoir, Bin ControlBin Controls Ice Level Sensors To Remove the Breaker Bearing Assembly Bearing and BreakerAuger To Remove the AugerWater Seal To Remove the Water SealRemoval of the Water Seal To Replace the Water Seal Replacing the Water SealTo Replace the Evaporator EvaporatorTo Reassemble the Evaporator and Auger To Remove and Repair the Gear Motor Assembly Gear MotorTo Check the Gear Motor To Inspect the Gear MotorTo Remove the Condenser Fan Motor Assembly Fan Blade and MotorRefrigeration Service Charging ProcedureGEM0650R Wiring Diagram Wiring Diagram GEM0650RGEM0956R Wiring Diagram Wiring Diagram GEM0956RGEM1256R Wiring Diagram Wiring Diagram GEM1256RService History What to Do Before Calling for Service