Ice-O-Matic GEM1256R, GEM0956R, GEM0650R Introduction, Keep this manual for future reference

Page 3

GEM0650/0956/1256 Remote

Introduction

How To Use This Manual

Ice-O-Matic provides this manual as an aid to the end user and service technician in installation and maintenance of the Pearl Ice™ Series ice machines. Do not attempt to perform installation, start-up or maintenance unless you have read and fully understand this manual.

If, at any time, you encounter conditions that are not addressed in this manual, call, E-mail or write the Ice-O-Matic Service Department:

Ice-O-Matic

11100 E. 45th Ave.

Denver, Co. 80239

Attn: Technical Service Department

E-Mail: Tech.service@iceomatic.com

Telephone Numbers		Any Service communication must include:
800-423-3367	All Departments	• Model Number
888-349-4423	Technical Assistance Only	• Serial number
303-371-3737		• A detailed explanation of the problem

Keep this manual for future reference.

The GEM0650R, GEM0956R and GEM1256R Service Parts Manuals are available separately.

Ice-O-Matic icemakers and dispensers are not approved for outdoor installation.

WARNING: Always disconnect electrical power and shut off water supply whenever maintenance or repairs are performed on the ice machine and related equipment.

CAUTION: Always wear protective eyewear whenever maintenance or repairs are performed on the ice machine and related equipment

Page i

Image 3

Contents By Ice-O-Matic Pearl Ice SeriesPage Keep this manual for future reference IntroductionTable Of Contents Concealed Loss or Damage Freight Claim ProcedureInspect Promptly Visible Loss or DamageGoverning LAW WarrantyFor the Installer GEM0650/0956R GEM1256R Bin Application Ice Machine SpecificationsWater Limitations LocationStorage Bin Ice machineLine Sets ERC Dimensions Inches GRC1001 GRC1061 GCR2061Remote Condenser Pearl Ice NumberRemote Condenser Location Calculation FormulaCalculation Example Remote Condenser Location Roof AttachmentPrecharged Line Set Routing Typical Installation Final Connections Coupling Instructions Initial ConnectionsFor the Plumber Water InletDrains Ice Machine For the Electrician Completed Installation Final Check List Start Up There are no adjustments to make, so replace the panelsStart Up Pre-Start InspectionComponent Description Control Board GEM0650/0956/1256 Remote Electrical Sequence Water System Operation WaterWater Water LevelOperation Refrigeration Refrigeration SchematicLow Condensing Temperature Pump Down Operation Performance Sanitizing and Cleaning Brush in direction of fins Condenser MaintenanceBearing Maintenance Bearing MaintenanceSensor Maintenance Bin Control SensorWater Sensor Auger Auger MaintenanceSymptom Possible Cause Probable Correction Service DiagnosisSymptom High pressure cut out check Control System DiagnosticsWater Reservoir, Bin Control Water ReservoirBin Controls Ice Level Sensors Bearing and Breaker To Remove the Breaker Bearing AssemblyTo Remove the Auger AugerReplacing the Water Seal Water SealTo Remove the Water Seal Removal of the Water Seal To Replace the Water SealEvaporator To Replace the EvaporatorTo Reassemble the Evaporator and Auger To Inspect the Gear Motor To Remove and Repair the Gear Motor AssemblyGear Motor To Check the Gear MotorFan Blade and Motor To Remove the Condenser Fan Motor AssemblyCharging Procedure Refrigeration ServiceWiring Diagram GEM0650R GEM0650R Wiring DiagramWiring Diagram GEM0956R GEM0956R Wiring DiagramWiring Diagram GEM1256R GEM1256R Wiring DiagramWhat to Do Before Calling for Service Service History