Ice-O-Matic GEM0956R, GEM1256R, GEM0650R Sensor Maintenance, Bin Control Sensor, Water Sensor

Page 34

GEM0650/0956/1256 Remote

Sensor Maintenance

Bin Control Sensor:

The bin control uses devices that sense light, therefore they must be kept clean enough so that they can “see”.

At least twice a year, remove the bin control sensors from the base of the chute, and wipe the inside clean, as illustrated.

Ice Level Sensors

Ice Discharge Chute

Slide In and Out

Water Sensor:

The ice machine uses a probe in the water reservoir to determine if there is water.

At least twice a year remove the probe from the reservoir and wipe the tip clean of mineral build-up.

Clean the probe’s tip with ice machine cleaner and a soft cloth.

Page 28

Image 34
Contents Pearl Ice Series By Ice-O-MaticPage Introduction Keep this manual for future referenceTable Of Contents Visible Loss or Damage Freight Claim ProcedureInspect Promptly Concealed Loss or DamageWarranty Governing LAWFor the Installer GEM0650/0956R GEM1256R Ice Machine Specifications Bin ApplicationIce machine LocationStorage Bin Water LimitationsPearl Ice Number ERC Dimensions Inches GRC1001 GRC1061 GCR2061Remote Condenser Line SetsCalculation Formula Remote Condenser LocationCalculation Example Roof Attachment Remote Condenser LocationPrecharged Line Set Routing Typical Installation Coupling Instructions Initial Connections Final ConnectionsWater Inlet For the PlumberDrains Ice Machine For the Electrician Completed Installation Final Check List Pre-Start Inspection There are no adjustments to make, so replace the panelsStart Up Start UpComponent Description Control Board GEM0650/0956/1256 Remote Electrical Sequence Water Level Operation WaterWater Water SystemRefrigeration Schematic Operation RefrigerationLow Condensing Temperature Pump Down Operation Performance Sanitizing and Cleaning Condenser Maintenance Brush in direction of finsBearing Maintenance Bearing MaintenanceBin Control Sensor Sensor MaintenanceWater Sensor Auger Maintenance AugerService Diagnosis Symptom Possible Cause Probable CorrectionSymptom Control System Diagnostics High pressure cut out checkWater Reservoir Water Reservoir, Bin ControlBin Controls Ice Level Sensors To Remove the Breaker Bearing Assembly Bearing and BreakerAuger To Remove the AugerRemoval of the Water Seal To Replace the Water Seal Water SealTo Remove the Water Seal Replacing the Water SealTo Replace the Evaporator EvaporatorTo Reassemble the Evaporator and Auger To Check the Gear Motor To Remove and Repair the Gear Motor AssemblyGear Motor To Inspect the Gear MotorTo Remove the Condenser Fan Motor Assembly Fan Blade and MotorRefrigeration Service Charging ProcedureGEM0650R Wiring Diagram Wiring Diagram GEM0650RGEM0956R Wiring Diagram Wiring Diagram GEM0956RGEM1256R Wiring Diagram Wiring Diagram GEM1256RService History What to Do Before Calling for Service