
SECTION 2: INSTALLATION/OPERATION INSTRUCTIONS
CHANGING THE AJ-44CE/CS DIRECTION OF TRAVEL
The
There may come times when it is necessary to change the direction of travel after the unit is installed. The instructions provided here are for maintenance personnel only. Unauthorized persons should not attempt any of the steps contained in these instructions.
Warning: many of the instructions and steps within this document require the use of tools and may also require that personnel change the wiring of the machine. Only authorized personnel should ever perform any maintenance evolution on the dishmachine!
PREPARATION
1.Power must be secured to the unit at the service breaker. Tag or lock out the service breaker to prevent acci- dental or unauthorized energizing of the machine.
2.Disconnect incoming water at the water pressure regulator or
3.Disconnect the service drain line from the drain plumbing of the dishmachine itself. Ensure that the unit is completely drained before doing this.
4.Remove the locking screw from the control box.
5.Remove the front dress panel.
TOOLS REQUIRED
The following tools will be needed to perform this maintenance evolution:
1.5/16” nutdriver
2.7/16” nutdriver
3.7/16” combination wrench
4.7/16” socket with drive ratchet and 4” extension
5.12” pipe wrench
6.10” adjustable wrench
7.Wire cutters
8.Phillipshead screwdriver
TIME REQUIRED
It is estimated that it will take (1) person three hours to perform this task, not including all of the items indicated in the section entitled “PREPARATION”.
IMPORTANT NOTES
1.Do not lose hardware! Place hardware in a safe spot away from the machine, ensuring that it does not fall loose into the machine tub. Hardware that is drawing into the suction of the wash pump will damage the equipment. If you do need more hardware, contact your JACKSON representa- tive to purchase new items.
2.Read these instructions thoroughly before attempt- ing this maintenance evolution. Become familiar with the parts and what actions need to be taken. This will save time in the long run!
STEPS
1.Remove the upper wash arm assembly by loosening the spin nut. The spin nut has a stop so it will not come off. Once it is loosened, the wash arm assembly should slide off.
Spin nut
2.Remove the end cap from the wash arm assembly and place in the opposite end, securing it snugly.
End cap
3.With the end cap securely in the opposite end of the wash arm assembly, set the assembly gently to the side. Go back inside the unit to where the upper wash arm assembly secured in the unit and turn the spin nut so that it is all the way down. This needs to be done because in a further step, if the spin nut is out, it will get in the way. Do not
Issued:
34