Jackson AJ-44 technical manual INSTALLATION/OPERATION Instructions

SECTION 2: INSTALLATION/OPERATION INSTRUCTIONS

CHANGING THE AJ-44CE/CS DIRECTION OF TRAVEL (CONTINUED)

Removing the hole cover weldment

22.Separate the rinse plumbing from the rest of the incoming plumbing by loosening the union. Ensure that the gasket on the bottom of the rinse injector stays with the assembly as you remove it.

Loosening the union on the incoming plumbing

23.Remove the remaining half of the union from the incoming plumbing.

28.Re-install the lower wash arm support bracket to the pawl bar support on the end of the tub opposite from where it was removed.

29.Re-install the upper and lower rinse arms. Reinstall the lower rinse arm support bracket.

30.Re-install the lower wash arm assembly, turning it 180° and locking it in place with the locking screw.

31.Re-install the pawl bar. Ensure that the pawl bar is placed so that when racks are placed in the unit, the pawl bar dogs fold down.

32.Re-install the upper wash arm assembly. If you performed all of the actions outlined in step 2, when you install it, it will be directly over the lower wash arm assembly.

33.Remove the heater box cover by unscrewing the four screws holding it on.

Removing the heater box cover

24.Remove the incoming water pressure regulator from the incoming plumbing and replace with the union half that was removed in step 23. Place the water pressure regulator on the end that the union half was removed from.

25.Place the removed rinse plumbing assembly (with the gas- ket) in the hole left open from when you removed the hole cover weldment in step 21. Tighten the two halves of the union together.

26.Place the hole cover weldment (with its gasket) over the hole from where the rinse plumbing assembly was originally installed. Tighten down with the locknuts.

27.Re-install the rinse manifold (with its gasket) by connect- ing it to the rinse injector weldment at its new location. Remove the locknut from the stud for the bracket down near the rack rails and then secure the bracket to the machine using the same lock nut.

1 2 3

Front of rack conveyor showing the conveyor

switches

AJ-44C Series Technical Manual 7610-001-76-22

Issued: 03-21-2006 Revised: N/A

38