Jackson AJ-44 Changing Dual Sanitization Mode, Drive Mechanism Maximum Speed Adjustment

SECTION 2: INSTALLATION/OPERATION INSTRUCTIONS

CHANGING DUAL SANITIZATION MODE

If the machine has a dataplate like the one shown, which indi- cates both Hot Water Sanitizing and Chemical Sanitizing operation parameters (the area within dashed box), it is pos- sible to change the sanitizing mode after the machine has left the original manufacturer's facility. This change can only be performed by an authorized Jackson service technician. If the machine does not have a dataplate like the one shown, the sanitization mode CAN NOT be changed.

Follow the instructions below to change the mode of sanitiza- tion. Failure to follow these instructions can result in a viola- tion of applicable regulatory codes.

DRIVE MECHANISM MAXIMUM SPEED ADJUSTMENT:

Note: This adjustment is only required when changing from hot water sanitizing to chemical sanitizing mode.

Locate the maximum speed adjustment mechanism at the top of the conveyor drive mechanism (Figure 1). Figure 2 shows an enlarged view of the maximum speed adjustment mecha- nism. Loosen the Bottom Jam Nut approximately one turn counterclockwise. Move the Top Jam Nut down on the threaded shaft by turning it approximately 1/2 turn counter- clockwise. Tighten the Adjustment Nut by turning it clockwise. Retighten the Bottom Jam Nut against the Top Jam Nut.

Figure 1: Drive Mechanism

			An	Company
MODEL:	XXXXXXXXX		SERIAL #	XXX XXXX X
			60 HZ 3 PHASE 3 WIRE
			208 V 230 V		460 V
WASH MOTOR		2.0 HP	5.6 A	5.6 A	2.8 A
DRIVE MOTOR		1/4 HP	1.1 A	1.1 A	0.6 A
WASH HEATER LOAD		15 KW	41.7 A	37.7 A	18.8 A
TOTAL AMP LOAD			48.4 A	44.4 A	22.2 A

HOT WATER		CHEMICAL
SANITIZING		SANITIZING
6.9 FPM	CONVEYOR SPEED	6.5 FPM
160° F MIN.	WASH TANK TEMPERATURE	140° F MIN.
180° F MIN.	FINAL RINSE TEMPERATURE	140° F MIN.
20 ±5 PSI	FLOW PRESSURE	20 ±5 PSI

NOTE: SEE INSTRUCTION IN MANUAL FOR MODIFYING MODE OF

SANITIZATION.

		US Patent Number(s):
	6,012,567
Commercial		Canadian Patent Number(s):
Dishwasher	2,205,331
597G		Made in the USA
		Jackson MSC Inc.
		P. O. Box 1060
		Barbourville, KY. 40906
		(606) 523-9795
		09905-021-70-81 E

Please note the parameters for both modes of sanitization. If your data plate has this information, it is convertible from one mode to another.

Adjustment Nut

Top Jam Nut

Bottom Jam Nut

Figure 2

AJ-44C Series Technical Manual 7610-001-76-22

Issued: 03-21-2006 Revised: 05-03-2007

48