Miele KM 326G manual Clearance above and around the appliance, Wall strips must be heat-resistant

Page 18

Clearance above and around the appliance

	min 33 1/4" (845 mm)
	min 33 1/14"
	(845 mm)
min 18"
(460 mm)
min 10"	min 10"
(254 mm)	(254 mm)

For safety reasons, ensure that the following minimum clearences are provided:

–between adjacent combustible construction 4” (100 mm).

not allowed

min. 10"

(254 mm)

– between appliance and rear wall 1 3/8”
(30 mm).

– between appliance and the overhead				not advisable
– between appliance and the overhead
combustible construction 33 1/4” (845 mm).

– between appliance and front edge of worktop 2 9/16” (65 mm).

– depth of overhead cabinets must not exceed 13” (330 mm).

– between combustible constructions and the extended cooking surface 18” (460 mm).

Wall strips must be heat-resistant.

recommended

Image 18

Contents T . n r 2 2 9 2 0 / T 9 1 7 0 1 B Mode demploi du kit de conversion AH 102 C4U English FrançaisPage Control knobs with marking Safety control Burner ringGeneral Marking Burner capPage Advice Important notes for the userBefore starting check High-speed and super high-speed burners Lighting and adjustingGas burners Zone super high-speed wok burner Outer ringMake sure the trivet is securely fixed to the pot support How to use gas burnersPlace the pot over the pot support fitted above the hob ˝ 50 mm between the pot and a heat-sensitive worktopCooking in comfort Are best done on the super high-speed wok BurnerMaking sauces Keeping food hot Cooking through/simmering Cleaning and maintenance Tab IndentationCont Appliance Ignition sparks but burner TroubleshootingProblem Cause Solution Burner does not burn well Does not igniteElectrical circuit diagram Electrical connection This appliance must be groundedFor USA only Gas pressures for USAFor Canada only Gas pressures for CanadaNominal rating natural gas 4˝ Building-in dimensions Clearance above and around the appliance Wall strips must be heat-resistantAir inlets at the back of the hob are clear Building-inPlace the hob in the cut-out. Check that Secure the hob in position. The bracketsPage Part Safety InstructionsConversion kit Type number AH 102 C4U Conversion instructionsFor future use DisassemblyConversion instructions IgniterPurposes. Check gas pressure. Permitted Locations of injectors and minimum adjustment screwsPressure regulator conversion High speed and super high speed burner ConversionHand side of the wok burner body a Wok burner outer ring conversionWok burner inner ring conversion WayTwo 12 mm wrenches are needed to separate the fittings Reference tableMinimum adjustment screws AssemblyThis concludes conversion. The hob can now be reassembled Installing appliance Testing converted applianceWarranty and service Energy source Technical detailsModel number KM 326G Gas source Overall wattage, electricity Total burnerrate Natural gasPage

Clearance above and around the appliance

not advisable

Wall strips must be heat-resistant.