Miele KM 326G manual Wok burner outer ring conversion, Wok burner inner ring conversion, Way

Page 24

Wok burner outer ring conversion

Outer ring injector (B)

The wok burner outer ring injector is located on the right hand side of the wok burner body (B).

Note

Outer ring airslot (B)

Adjust the air slot on the outer ring injector now. The correct distance for the air slot (B) is 0.083". Slide the brass tube to the prescribed distance and tighten the holding screw at the rear of the tube.

Wok burner inner ring conversion

	Inner ring injector (A)
1. Unscrew the screw holding the brass tube to
the left of the injector. Access this screw	The inner ring injector is located on the left
from the rear. Slide the brass tube to the left,	hand side of the wok burner body (A).
but do not insert it into the aluminium tube all
the way.
2. Use a 10 mm wrench and unscrew the outer
ring injector. Support the aluminium gas pipe
feeding the injector by holding it down, while
turning the wrench. Unscrew the injector
and replace it with the injector marked 090
(170, natural gas).
22

Image 24

Contents T . n r 2 2 9 2 0 / T 9 1 7 0 1 B Mode demploi du kit de conversion AH 102 C4U English FrançaisPage Safety control Burner ring General MarkingControl knobs with marking Burner capPage Advice Important notes for the userBefore starting check Lighting and adjusting Gas burnersHigh-speed and super high-speed burners Zone super high-speed wok burner Outer ringHow to use gas burners Place the pot over the pot support fitted above the hobMake sure the trivet is securely fixed to the pot support ˝ 50 mm between the pot and a heat-sensitive worktopCooking in comfort Are best done on the super high-speed wok BurnerMaking sauces Keeping food hot Cooking through/simmering Cleaning and maintenance Tab IndentationCont Appliance Troubleshooting Problem Cause Solution Burner does not burn wellIgnition sparks but burner Does not igniteElectrical circuit diagram Electrical connection This appliance must be groundedFor USA only Gas pressures for USAFor Canada only Gas pressures for CanadaNominal rating natural gas 4˝ Building-in dimensions Clearance above and around the appliance Wall strips must be heat-resistantBuilding-in Place the hob in the cut-out. Check thatAir inlets at the back of the hob are clear Secure the hob in position. The bracketsPage Safety Instructions Conversion kit Type number AH 102 C4UPart Conversion instructionsDisassembly Conversion instructionsFor future use IgniterLocations of injectors and minimum adjustment screws Pressure regulator conversionPurposes. Check gas pressure. Permitted High speed and super high speed burner ConversionWok burner outer ring conversion Wok burner inner ring conversionHand side of the wok burner body a WayTwo 12 mm wrenches are needed to separate the fittings Reference tableMinimum adjustment screws AssemblyThis concludes conversion. The hob can now be reassembled Installing appliance Testing converted applianceWarranty and service Technical details Model number KM 326G Gas sourceEnergy source Overall wattage, electricity Total burnerrate Natural gasPage

Wok burner outer ring conversion

Wok burner inner ring conversion

hand side of the wok burner body (A).

the way.