Miele KM 326G manual For USA only, Gas pressures for USA

Page 15

Warning

As shown in the above diagram, the regulator included must be used when connecting the Miele hob.

–Any pipe connections must be made using a thread sealant approved for gas connections. Failure to correctly install these items could lead to a gas leak and subsequent explosion.

–Do not use any regulator unless it has been supplied by Miele Appliances.

Connect the gas supply to the pressure regulator using a 1/2” gas line connector between the shut-off valve and the pressure regulator. Flexible harmonica-type stainless steel pipe is recommended.

For USA only

The gas connection must be made in accordance with the local codes, or in absence of local codes, with the National Fuel Gas Code ANSI Z 223.1.

Gas pressures for USA
Natural gas
Max. supply pressure:	1/2 psi
Min. supply pressure:	5˝ water column

Liquid propane gas, after converting this appliance with conversion kit number AH102 C4U.

Max. supply pressure:	1/2 psi
Min. supply pressure:	11˝ water column
Manifold pressure:
– natural gas	4˝ water column
– propane gas	10˝ water column

13

Image 15

Contents T . n r 2 2 9 2 0 / T 9 1 7 0 1 B English Français Mode demploi du kit de conversion AH 102 C4UPage Burner cap Safety control Burner ringGeneral Marking Control knobs with markingPage Advice Important notes for the userBefore starting check Zone super high-speed wok burner Outer ring Lighting and adjustingGas burners High-speed and super high-speed burners˝ 50 mm between the pot and a heat-sensitive worktop How to use gas burnersPlace the pot over the pot support fitted above the hob Make sure the trivet is securely fixed to the pot supportCooking in comfort Are best done on the super high-speed wok BurnerMaking sauces Keeping food hot Cooking through/simmering Tab Indentation Cleaning and maintenanceCont Appliance Does not ignite TroubleshootingProblem Cause Solution Burner does not burn well Ignition sparks but burnerElectrical circuit diagram This appliance must be grounded Electrical connectionGas pressures for USA For USA onlyFor Canada only Gas pressures for CanadaNominal rating natural gas 4˝ Building-in dimensions Wall strips must be heat-resistant Clearance above and around the applianceSecure the hob in position. The brackets Building-inPlace the hob in the cut-out. Check that Air inlets at the back of the hob are clearPage Conversion instructions Safety InstructionsConversion kit Type number AH 102 C4U PartIgniter DisassemblyConversion instructions For future useHigh speed and super high speed burner Conversion Locations of injectors and minimum adjustment screwsPressure regulator conversion Purposes. Check gas pressure. PermittedWay Wok burner outer ring conversionWok burner inner ring conversion Hand side of the wok burner body aReference table Two 12 mm wrenches are needed to separate the fittingsMinimum adjustment screws AssemblyThis concludes conversion. The hob can now be reassembled Testing converted appliance Installing applianceWarranty and service Overall wattage, electricity Total burnerrate Natural gas Technical detailsModel number KM 326G Gas source Energy sourcePage