Miele Complete Guide for Installing and Testing KM 326G Cooktops

Page 27

Installing appliance

Testing converted appliance

1.Install the appliance according to the installation instructions.

2.Attach the moulding at the rear to the undertray. Put the hob back in the work surface and fasten the bracket clamps underneath the work surface.

3.Set the gas pressure regulator to a new pressure of 10” WC (4" WC, natural gas). Check pressure (see page 21). Permitted pressures: minimum 11” WC (5" WC, natural gas), max. 1/2 psi.

4.Reconnect gas supply, reconnect the manifold pipe, reconnect the electrical power.

5.Put the burner heads and pan supports in place. Make sure the burner heads are mounted the right way. Put the burner head marked "A" on top of the wok burner.

Note

This appliance has been internally tested for gas leakages by the manufacturer.

Caution

Check converted hob for gas leaks. Check the connection with a soapy solution. Never use a flame of any sort.

Check that the hob functions normally:

Turn on the gas supply and plug in the power supply cord.

Light each of the burners individually.

When the burner is at low setting, or when the control knob is turned quickly from 'high' to 'low', the flame should not go out.

When set at 'high', the gas flame must burn with the center clearly visible.

Locations of injectors and minimum

adjustment screws

(Natural gas)	(034)		(170)		(166)		(145)
Propane gas	007		090		087		075

Propane gas	054 025 036 040 036 040	075	087
(Natural gas)	(100)(042) (055)(060) (055)(060)	(145)	(166)

25

Image 27

Contents T . n r 2 2 9 2 0 / T 9 1 7 0 1 B English Français Mode demploi du kit de conversion AH 102 C4UPage Burner cap Safety control Burner ringGeneral Marking Control knobs with markingPage Advice Important notes for the userBefore starting check Zone super high-speed wok burner Outer ring Lighting and adjustingGas burners High-speed and super high-speed burners˝ 50 mm between the pot and a heat-sensitive worktop How to use gas burnersPlace the pot over the pot support fitted above the hob Make sure the trivet is securely fixed to the pot supportCooking in comfort Are best done on the super high-speed wok BurnerMaking sauces Keeping food hot Cooking through/simmering Tab Indentation Cleaning and maintenanceCont Appliance Does not ignite TroubleshootingProblem Cause Solution Burner does not burn well Ignition sparks but burnerElectrical circuit diagram This appliance must be grounded Electrical connectionGas pressures for USA For USA onlyFor Canada only Gas pressures for CanadaNominal rating natural gas 4˝ Building-in dimensions Wall strips must be heat-resistant Clearance above and around the applianceSecure the hob in position. The brackets Building-inPlace the hob in the cut-out. Check that Air inlets at the back of the hob are clearPage Conversion instructions Safety InstructionsConversion kit Type number AH 102 C4U PartIgniter DisassemblyConversion instructions For future useHigh speed and super high speed burner Conversion Locations of injectors and minimum adjustment screwsPressure regulator conversion Purposes. Check gas pressure. PermittedWay Wok burner outer ring conversionWok burner inner ring conversion Hand side of the wok burner body aReference table Two 12 mm wrenches are needed to separate the fittingsMinimum adjustment screws AssemblyThis concludes conversion. The hob can now be reassembled Testing converted appliance Installing applianceWarranty and service Overall wattage, electricity Total burnerrate Natural gas Technical detailsModel number KM 326G Gas source Energy sourcePage