Miele KM 326G manual Safety Instructions, Conversion kit Type number AH 102 C4U, Part

Page 21

Safety Instructions

Parts

Warning

This conversion kit must be installed by a qualified service agency.

This conversion kit is for use with Miele gas hob KM 326G only.

Conversion kit

type number AH 102 C4U

These conversion instructions are to be used together with the operating and installation instructions.

Right

Wrong

Check to ensure that the burner is burning correctly. The flames should be blue and uniform.

Right

Wrong

This conversion kit includes the following parts:

Part	ID number		Number
Burner cap		A	1
Injector wok burner
outer ring		090	1
Injector wok burner inner ring		007	1
Injector super high-speed
burner C		087	2
Injector high-speed burner B		075	2
Low flame screw outer
wok burner		054	1
Low flame screw inner
wok burner		025	1
Low flame screw burner C		040	2
Low flame screw burner B		036	2

Conversion instructions

Data plate LP gas 10” W.C.

Conversion data plate

This appliance is to be converted to Propane 10” W.C. (2.491 kPa) only.

Input ratings LP gas

. . . . . . . .high speed burner	7000	Btu/hr
super high speed burner	9200	Btu/hr
wok burner inner ring	1125	Btu/hr
wok burner outer ring	11200	Btu/hr

If the flames are not uniform, check to ensure that the burner cap is properly positioned on the ring.

If the flames are irregular and yellow, check to ensure that a pressure regulator has been

installed. Do not use the appliance and inform

the installer.

19

Image 21

Contents T . n r 2 2 9 2 0 / T 9 1 7 0 1 B English Français Mode demploi du kit de conversion AH 102 C4UPage General Marking Safety control Burner ringControl knobs with marking Burner capPage Advice Important notes for the userBefore starting check Gas burners Lighting and adjustingHigh-speed and super high-speed burners Zone super high-speed wok burner Outer ringPlace the pot over the pot support fitted above the hob How to use gas burnersMake sure the trivet is securely fixed to the pot support ˝ 50 mm between the pot and a heat-sensitive worktopCooking in comfort Are best done on the super high-speed wok BurnerMaking sauces Keeping food hot Cooking through/simmering Tab Indentation Cleaning and maintenanceCont Appliance Problem Cause Solution Burner does not burn well TroubleshootingIgnition sparks but burner Does not igniteElectrical circuit diagram This appliance must be grounded Electrical connectionGas pressures for USA For USA onlyFor Canada only Gas pressures for CanadaNominal rating natural gas 4˝ Building-in dimensions Wall strips must be heat-resistant Clearance above and around the appliancePlace the hob in the cut-out. Check that Building-inAir inlets at the back of the hob are clear Secure the hob in position. The bracketsPage Conversion kit Type number AH 102 C4U Safety InstructionsPart Conversion instructionsConversion instructions DisassemblyFor future use IgniterPressure regulator conversion Locations of injectors and minimum adjustment screwsPurposes. Check gas pressure. Permitted High speed and super high speed burner ConversionWok burner inner ring conversion Wok burner outer ring conversionHand side of the wok burner body a WayReference table Two 12 mm wrenches are needed to separate the fittingsMinimum adjustment screws AssemblyThis concludes conversion. The hob can now be reassembled Testing converted appliance Installing applianceWarranty and service Model number KM 326G Gas source Technical detailsEnergy source Overall wattage, electricity Total burnerrate Natural gasPage