Miele KM 326G manual Building-in, Place the hob in the cut-out. Check that

Page 19

Building-in

1.Make the cut-out in the work surface. Ensure that there is sufficient space allowed at the sides and at the rear.

2.Attach the sealing strip to the underside of the hob and the aeration profile.

3.* Connect the pressure regulator supplied at
	the angle-joint, ensuring that they are
	positioned correctly. (See also
	“Gas Connection”.)
		glass shield
4.	Place the hob in the cut-out. Check that the	sealing tape
4.	Place the hob in the cut-out. Check that the
	air inlets at the back of the hob are clear.	worktop
	air inlets at the back of the hob are clear.
5.	Secure the hob in position. The brackets	wooden block
		wooden block
	clamp underneath the work surface.
		burner box
6.	Make the gas connection. Check the gas
	connections with a soapy solution.
7.	Put the plug in the socket (see "Electrical
	Connection").
8.	Test to check that the hob is operational.

* Undertray is positioned on work surface.

Image 19

Contents T . n r 2 2 9 2 0 / T 9 1 7 0 1 B English Français Mode demploi du kit de conversion AH 102 C4UPage Burner cap Safety control Burner ringGeneral Marking Control knobs with markingPage Important notes for the user AdviceBefore starting check Zone super high-speed wok burner Outer ring Lighting and adjustingGas burners High-speed and super high-speed burners˝ 50 mm between the pot and a heat-sensitive worktop How to use gas burnersPlace the pot over the pot support fitted above the hob Make sure the trivet is securely fixed to the pot supportAre best done on the super high-speed wok Burner Cooking in comfortMaking sauces Keeping food hot Cooking through/simmering Tab Indentation Cleaning and maintenanceCont Appliance Does not ignite TroubleshootingProblem Cause Solution Burner does not burn well Ignition sparks but burnerElectrical circuit diagram This appliance must be grounded Electrical connectionGas pressures for USA For USA onlyGas pressures for Canada For Canada onlyNominal rating natural gas 4˝ Building-in dimensions Wall strips must be heat-resistant Clearance above and around the applianceSecure the hob in position. The brackets Building-inPlace the hob in the cut-out. Check that Air inlets at the back of the hob are clearPage Conversion instructions Safety InstructionsConversion kit Type number AH 102 C4U PartIgniter DisassemblyConversion instructions For future useHigh speed and super high speed burner Conversion Locations of injectors and minimum adjustment screwsPressure regulator conversion Purposes. Check gas pressure. PermittedWay Wok burner outer ring conversionWok burner inner ring conversion Hand side of the wok burner body aReference table Two 12 mm wrenches are needed to separate the fittingsAssembly Minimum adjustment screwsThis concludes conversion. The hob can now be reassembled Testing converted appliance Installing applianceWarranty and service Overall wattage, electricity Total burnerrate Natural gas Technical detailsModel number KM 326G Gas source Energy sourcePage

Building-in

Place the hob in the cut-out. Check that the

air inlets at the back of the hob are clear.

Secure the hob in position. The brackets

clamp underneath the work surface.