1.First loosen the 8 mm ring securing the gas feed pipe. Disconnect the gas pipe. The actual injector is a thin metal cap mounted between the two brass fittings attached to the left of the wok burner body.
6.Reattach the gas pipe and tighten the 8 mm ring.
Note
gaspipe injector
AB
Inner ring air slot (A)
Inner ring injector
2.Two 12 mm wrenches are needed to separate the fittings.
Use one 12 mm wrench to keep the right- hand fitting in place, while using the other
12 mm wrench to loosen the
3.With the left fitting loosened, unscrew the
4.Holding them vertical, take both fittings apart. The metal cap with the injector will remain on top of the lower fitting. Replace the injector cap with the injector cap marked 007 (034, natural gas) and put the two fittings back together.
Warning
Make sure that the natural gas injector is removed from the fitting when the propane gas injector is installed.
5.Screw the assembled fittings back into the wok burner body. Carefully tighten both fittings. Do not overtighten.
Adjust the air slot on the inner ring injector now. The slot is adjusted by shifting the metal clip around the
Reference table
LP gas |
|
|
|
| adjustment |
| injector | screw |
0.75 mm | 0.36 mm | |
| 0.03” | 0.014” |
super | 0.87 mm | 0.40 mm |
| 0.034” | 0.016” |
wok burner inner ring | 0.50 mm | 0.25 mm |
| 0.02” | 0.01” |
wok burner outer ring | 0.90 mm | 0.54 mm |
| 0.035” | 0.021” |
|
|
|
|
|
|
natural gas |
|
|
|
| adjustment |
| injector | screw |
1.45 mm | 0.55 mm | |
super | 1.66 mm | 0.60 mm |
wok burner inner ring | 0.60 mm | 0.42 mm |
wok burner outer ring | 1.70 mm | 1.00 mm |
|
|
|
23