Miele KM 326G manual Pressure regulator conversion, Purposes. Check gas pressure. Permitted

Page 23

Pressure regulator conversion

The pressure regulator is located on the gas supply pipe. Unscrew and remove the brass cap in the centre of the regulator. This gas regulator is only adjustable for 4" and 10" gas pressure. There is a blue plastic pin on the inside of the cap, marked "NAT" and "LP". Pull this pin from the cap and insert it the other way round. Snap the pin into the cap. The pin must be positioned as in the drawing above. The regulator is now adjusted for propane gas 10" WC. (For natural gas 4", turn the pin back.) Screw the cap back on the regulator. The pressure regulator is equipped with a separate connection for pressure testing

purposes. Check gas pressure. Permitted

pressures: min. 11" WC (5" WC, natural gas), max.

1/2 psi.

High speed and super high speed burner

conversion

Unscrew and replace injectors on the high- speed and super high-speed burners. Replace each injector separately. Refer to illustration “Locations of injectors and minimum adjustment screws” for screw locations.

Locations of injectors and minimum adjustment screws

(Natural gas)	(034)		(170)		(166)				(145)
LP gas	007		090		087				075

LP gas	054 025 036 040 036 040	075	087
(Natural gas)	(100)(042) (055)(060) (055)(060)	(145)	(166)

21

Image 23

Contents T . n r 2 2 9 2 0 / T 9 1 7 0 1 B English Français Mode demploi du kit de conversion AH 102 C4UPage Burner cap Safety control Burner ringGeneral Marking Control knobs with markingPage Before starting check AdviceImportant notes for the user Zone super high-speed wok burner Outer ring Lighting and adjustingGas burners High-speed and super high-speed burners˝ 50 mm between the pot and a heat-sensitive worktop How to use gas burnersPlace the pot over the pot support fitted above the hob Make sure the trivet is securely fixed to the pot supportMaking sauces Keeping food hot Cooking through/simmering Cooking in comfortAre best done on the super high-speed wok Burner Tab Indentation Cleaning and maintenanceCont Appliance Does not ignite TroubleshootingProblem Cause Solution Burner does not burn well Ignition sparks but burnerElectrical circuit diagram This appliance must be grounded Electrical connectionGas pressures for USA For USA onlyNominal rating natural gas 4˝ For Canada onlyGas pressures for Canada Building-in dimensions Wall strips must be heat-resistant Clearance above and around the applianceSecure the hob in position. The brackets Building-inPlace the hob in the cut-out. Check that Air inlets at the back of the hob are clearPage Conversion instructions Safety InstructionsConversion kit Type number AH 102 C4U PartIgniter DisassemblyConversion instructions For future useHigh speed and super high speed burner Conversion Locations of injectors and minimum adjustment screwsPressure regulator conversion Purposes. Check gas pressure. PermittedWay Wok burner outer ring conversionWok burner inner ring conversion Hand side of the wok burner body aReference table Two 12 mm wrenches are needed to separate the fittingsThis concludes conversion. The hob can now be reassembled Minimum adjustment screwsAssembly Testing converted appliance Installing applianceWarranty and service Overall wattage, electricity Total burnerrate Natural gas Technical detailsModel number KM 326G Gas source Energy sourcePage