Miele KM 326G manual Minimum adjustment screws, Assembly

Page 26

Minimum adjustment screws

1.Lift and remove the small black ring if this is still on the regulator shaft (see note in "Disassembly").

2.Lift and remove the square black switches. Do not disconnect the wires from the switches or the light emitting diodes (LED).

The wok burner is equipped with two minimum adjustment screws, one for each burner ring.

Note

Make sure you replace both minimum adjustment screws. Put screw 054 (100, natural gas) on the left, 025 (042, natural gas) on the right.

Use a small screwdriver and replace each screw individually.

24

3.Put the black switches with the light emitting diodes back in place.

4.Attach the label 'This control has been converted for use with propane gas' to the top of the hob undertray. Attach it as close to the controls as possible.

5.Fill in the conversion date label and attach conversion kit identification label close to the appliance's original identification plate.

Note

This concludes conversion. The hob can now be reassembled.

Assembly

1.Check that the seals are fitted on the ceramic tray. Put the ceramic tray on the hob. Make sure it is correctly positioned on the undertray. Put the black ring around the regulator shaft as shown. Press the black rings into the seals. Put the control knobs back.

2.Put the wok burner base plate back in place. Fasten the three screws securing the wok burner base plate.

3.Connect the wires to the ignition plugs. Put the high-speed and super high-speed burner base plates and burner rings back. Fasten the high-speed and super high-speed venturis using a 20 mm wrench.

Image 26

Contents T . n r 2 2 9 2 0 / T 9 1 7 0 1 B Mode demploi du kit de conversion AH 102 C4U English FrançaisPage Control knobs with marking Safety control Burner ringGeneral Marking Burner capPage Before starting check AdviceImportant notes for the user High-speed and super high-speed burners Lighting and adjustingGas burners Zone super high-speed wok burner Outer ringMake sure the trivet is securely fixed to the pot support How to use gas burnersPlace the pot over the pot support fitted above the hob ˝ 50 mm between the pot and a heat-sensitive worktopMaking sauces Keeping food hot Cooking through/simmering Cooking in comfortAre best done on the super high-speed wok Burner Cleaning and maintenance Tab IndentationCont Appliance Ignition sparks but burner TroubleshootingProblem Cause Solution Burner does not burn well Does not igniteElectrical circuit diagram Electrical connection This appliance must be groundedFor USA only Gas pressures for USANominal rating natural gas 4˝ For Canada onlyGas pressures for Canada Building-in dimensions Clearance above and around the appliance Wall strips must be heat-resistantAir inlets at the back of the hob are clear Building-inPlace the hob in the cut-out. Check that Secure the hob in position. The bracketsPage Part Safety InstructionsConversion kit Type number AH 102 C4U Conversion instructionsFor future use DisassemblyConversion instructions IgniterPurposes. Check gas pressure. Permitted Locations of injectors and minimum adjustment screwsPressure regulator conversion High speed and super high speed burner ConversionHand side of the wok burner body a Wok burner outer ring conversionWok burner inner ring conversion WayTwo 12 mm wrenches are needed to separate the fittings Reference tableThis concludes conversion. The hob can now be reassembled Minimum adjustment screwsAssembly Installing appliance Testing converted applianceWarranty and service Energy source Technical detailsModel number KM 326G Gas source Overall wattage, electricity Total burnerrate Natural gasPage