Gas burners
If a burner blows out, the electronic ignition automatically sparks all burners to relight the flame.
The flame is lit by means of an electrical ignition device. When the burner control is pressed and turned, a high voltage flows into the electrode by the burner. Sparks are created. A spark ignites the gas to give a flame.
Lighting and adjusting
OFF
HI
LO
high-speed and super high-speed burners
A symbol above the control knob indicates which burner is being operated.
–Push in the burner control knob and turn it to the “HI” position. Ignition follows.
–Turn the control to the desired setting once the burner is alight. The LED’s indicate the position of the control knob.
You may set the knob at any position between “HI” and “LO”.
OFF
HI | XLO |
LO
2-zone super high-speed wok burner
Outer ring
–Push in the burner control knob and turn it to the “HI” position. Ignition follows.
–Turn the control to the desired setting once the burner is alight.
You may set the knob at any position between “HI” and “LO”.
Inner ring
–Push in the burner control knob and turn it to the “HI” position. Ignition follows.
–Turn the control to “LO” once the burner is alight.
–Push in the burner control knob and turn it to any position between “LO” and “XLO”.
5