Vulcan-Hart ML-136649 Leveling the Fryer, Operation, OVER-TEMPERATURE Shutdown, Before First USE

Page 10

GBD_GBDF SERIES GAS FRYERS

LEVELING THE FRYER

Check the level of the fryer by placing a level on top of the fryer after gas connections have been made.

Ensure that the fryer is level front-to-back and side-to-side in the final installed position.

If using casters, lock the wheels after unit is level.

OPERATION

Hot oil and parts can cause burns. Use care when operating, cleaning and servicing the fryer.

Spilling hot frying compound can cause severe burns. Do not move fryer without draining all frying compound from the tank.

OVER-TEMPERATURE SHUTDOWN

If the shortening becomes overheated, a high-temperature shutoff device will turn the gas valve off and extinguish the pilot.

If the fryer shuts down due to overheating, do not turn fryer on until the shortening temperature is below 300°F (149°C).

If an overheating situation persists, contact your local Vulcan-Hart authorized service office.

BEFORE FIRST USE

Cleaning

New units are wiped down at the factory to remove any visible signs of dirt, oil, grease, etc. remaining from the manufacturing process.

Before any food preparation, thoroughly wash the protective oil from all surface parts and the tank interior with hot soapy water to remove any film residue and dust or debris.

Do not use chlorine or sulfate/sulfide cleaners.

ŠWash any accessories shipped with unit.

•Rinse fryer and accessories thoroughly and drain the fryer.

ŠWipe tank completely dry with a soft, clean cloth.

VULCAN-HART

F-32934 Rev. B (June 2008)

-10-

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Installation & Operational Manual Important for Your Safety Table of Contents Unpacking IntroductionOrdering Parts GeneralInstallation Fryer Model No Device Serial NoLocation Codes and StandardsClearances United StatesFlue Connection AssemblyCanada GAS Pressures ALL Models Testing the GAS Supply Piping SystemGAS Connection Fryers with CastersElectrical Connection Leveling the Fryer OVER-TEMPERATURE ShutdownCleaning OperationFilling Tank with Shortening Basic Frying InstructionFry Basket Guidelines Extending Shortening LifeFry Basket Capacity Turning OFF the Fryer Turning on the FryerStart Button Extended Shutdown Filtering the OILWeekly or when oil is replaced Boil OUT ProcedureDraining the Tank Cleaning GAS KleenScreen Plus Models Filtering Instructions for KleenScreen Plus Fryers Same Suction Tube Do not Wash Fabric Envelope StepFiltering Procedure OperationQuick Start Guide for Solid State Knob Controls Filtering in 6 Easy Steps Removing Excess Debris from the Screen Filter Filtering TIPFlush and Discard Boil OUT Procedure Thermal Overload Protection ButtonFlue Vent Inspection MaintenanceService in the US and Canada Australia
Top Page Image Contents